Használati útmutató Draper 253219 projection screen 253219

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Draper 253219 projection screen 253219 (2 oldal) a Vetítővászon kategóriában. Ezt az útmutatót 34 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.8 csillagra

Assembly/Mounting Instructions

Onyx Permanently Tensioned Projection Screen by Draper

Caution

①Read instructions through completely before proceeding.

②Follow instructions carefully. Installation con trary to instructions

invalidates warranty.

③Screen should be accessible for complete removal should fabric

become damaged or should other ser vice be required.

④Screen should be installed level (using a carpenter’s level).

⑤Nothing should be fastened to screen frame or viewing surface.

⑥Make sure you have received all parts (see parts list below and

exploded diagram on page 2).

⑦Tools Required: Medium (#2) Phillips screwdriver (6" or greater shaft

length suggested). Optional tools: Flat blade screwdriver or small

putty knife.

⑧Installer is responsible for providing appropriate hardware for mounting.

⑨When lifting assembled screen, do not lift at only one corner; lift at

both corners. Lifting by one corner could result in damage to the

screen frame, especially on large screens.

⑩ The ideal temperature range for assembling folding screens to prevent

damaging the surface is 68°-78° F (20°-26° C). Assembling below

recommended temperatures may damage surface and void warranty.

NOTE: Screen has been thoroughly inspected and tested at factory and

found to be operating properly prior to shipment.

Copyright © 2010 Draper Inc. Form Onyx_Inst10 Printed in U.S.A.

®

If you encounter any diffi culties installing or ser vic ing your Onyx screen, call your

dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999 or fax (765) 987-7142.

Onyx—Hardware and Parts List

Frame Preparation

①Clean area and place frame assembly pieces face down. Insert plastic

corner pieces into ends of aluminum frame extrusions as indicated in

Figures 1 through 4. Secure each corner to each frame extrusion by

threading one #10-24 fastener through hole in plastic corner and into

rounded slot in aluminum frame extrusion.

Caution: Do not over-tighten fasteners—over-tightening could cause

damage to the frame corners.

Figure 1

②Secure corner pieces to aluminum frame extrusions with four (4) remaining

fasteners. Check to verify that all four (4) plastic corners are secure to

aluminum frame extrusion lengths and all eight (8) fasteners are tight (see

Fig. 5).

Caution: Do not over-tighten fasteners—over-tightening could cause

damage to the frame corners.

Figure 2

Frame Extrusions - 4

Frame Corners - 4

#10-24 fasteners - 8

Z-Brackets - 2

Viewing Surface - 1

Plastic Tubing - 4

Surface Retention

Extrusions- 4

Front

Back

Figure 3

Figure 5

Figure 4

(Continued on Page 2)

Patented by Draper, Inc., U.S. Patent Nos. 6,785,047; 7,113,332; and 7,369,310.

Caution: When lifting assembled screen, do not lift at only one corner; lift

at both corners. Lifting by one corner could result in damage to the screen

frame, especially on large screens.

Termékspecifikációk