Használati útmutató Electro Harmonix Nano Looper 360

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Electro Harmonix Nano Looper 360 (24 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 10 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 5.0 csillagra

1

NANO LOOPER 360

Compact Looper

Congratulations on your purchase of the Nano Looper 360The Nano Looper 360 is ! a

small, extremely easy to use looper with a total of -seconds of loop recording time. Not 360

only that, the available 360 seconds can be divided into 11 different Loops, so you get the

most out of the available memory! You can think of the Nano Looper 360 as your very own

“Loop Locker. ”

WARNING: Your Nano Looper 360 comes equipped with an Electro-Harmonix 9.6DC-

200BI power supply (same as used by Boss® & Ibanez®: 9.6 Volts DC 200mA). The Nano

Looper 360 requires 90mA at 9VDC with a center negative plug. Using the wrong adapter

or plug polarity may damage your unit and void the warranty.

– –FEATURES

-6 minutes of loop recording time

-selectableindependent Loops11 , , that remain in memory until you erase them

-High qualityuncompressed audio: -bit A/D/A, 44.1k Sample Rate , 24Hz

-Intuitive looping interface

-Undo-Redo function

-Unlimited overdubbing

-Small pedal board footprint

-AC Adapter Included

-tionally may use 9V Alkaline Battery, battery life: approximately 4 hours of operation Op

(varies on conditions of use)

– –CONTROLS

LEVEL Knob –Controls the output level of the Loop. Your dry signal remains at unity

signal level from input to output. The dry signal also remains analog throughout the . 360

LOOP Knob Selects number: 1-11. When scrolling through loops, the –Loop MEM LED

flash quickly during transitions. If the loop has no recorded memory, the esMEM LED

remains off. If the loop has recorded memory, the remains and playback can MEM LEDon

begin.

INPUT Jack Nano Looper 360. The input –This ¼” jack is the audio input for the

impedance is 2.2M. 

OUTPUT Jack Nano Looper 360. The output –This ¼” jack is the audio output from the

impedance is 470.

9V Power Jack– Plug the output of the supplied AC adapter into the 9V power jack

located at the top of the Nano Looper 360. The Nano Looper 360 draws mA at 9VDC 90

with a center negative plug. The Nano Looper 360 accepts Boss® and Ibanez® style AC

Adapters.

Termékspecifikációk