Használati útmutató Eltako DL-RM16A-HS-WE
Eltako
nincs kategorizálva
DL-RM16A-HS-WE
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Eltako DL-RM16A-HS-WE (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 5 ember találta hasznosnak és 3 felhasználó értékelte átlagosan 4.4 csillagra
Oldal 1/1

Module to control a relay contact over the
DALI bus (DT7) for DIN top-hat rails DIN-EN
60715 TH35. 98x17,5x56 mm. Protection
class IP20. DALI current consumption 2.7 mA.
Compact relay module for direct control of
230 V loads over DALI. Loads without DALI
input are easily integrated in a DALI circuit.
Loads can be switched on/off by DALI com-
mands. The device function complies with
the standard for DALI Device Type 7 – switching
function (as of Firmware 2.0). Adjustable
characteristic for power-up and bus power
failure.
The DALI RM16 is powered over the DALI bus.
No additional power supply is required.
Zero passage switch-on. Integrated power-
on current limit, particularly suitable for
loads with very high power-on current
(> 100 A). The interface represents a bus
user and is therefore addressable.
Conguration via DALI Cockpit PC software.
DALI functions and command set:
The DALI RM16 can integrate loads on the
DALI bus and can then switch them on/off.
The DALI RM16 is a control device for non-
dimmable loads based on the DALI speci-
cations in IEC 62386-208 (Device Type 7).
Accordingly, the switch characteristic is
determined by comparing the virtual dim
level (VDAP) with 4 switching thresholds.
The virtual dim level (VDAP) corresponds to
the dim level of a DALI electronic ballast with
DT7 switching actuator
DL-RM16A-HS-WE
GB
Temperature at mounting location:
-20°C up to +50°C.
Storage temperature: -25°C up to +70°C.
Relative humidity:
annual average value <75%.
33 000 006 - 1
Only skilled electricians may install this
electrical equipment otherwise there is
the risk of re or electric shock!
its corresponding characteristics (limited
by MINLEVEL and MAXLEVEL, dimming
speed limited by fade time and fade rate).
There are 2 switching thresholds in each
dimming direction and they are used for
comparison with the virtual dim level. Only
the applicable switching threshold for the
current virtual dimming direction is evaluated.
A threshold with the value 'MASK' is inactive
and is not used in the comparison.
Switch-on/off delays can be implemented
with fading.
The DALI RM16 is powered from the DALI bus.
The relay response to a bus power failure can
be congured by the SystemFailureLevel
(no change, ON or OFF, factory setting: ON).
The power-on response after applying bus
power can be set with PowerOnLevel.
Technical data
Max. connected current 16 A
Screw terminals:
Max conductor
cross-section 2,5 mm2
Must be kept for later use!
Eltako GmbH
D-70736 Fellbach
Technical Support English:
+49 711 94350025
technical-support@eltako.de
eltako.com
05/2022 Subject to change without notice.
The crossed-out waste container indicates
that batteries may not be disposed with
other household or commercial waste.
Termékspecifikációk
Márka: | Eltako |
Kategória: | nincs kategorizálva |
Modell: | DL-RM16A-HS-WE |
Szüksége van segítségre?
Ha segítségre van szüksége Eltako DL-RM16A-HS-WE, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók nincs kategorizálva Eltako
29 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
28 Augusztus 2024
Útmutatók nincs kategorizálva
- nincs kategorizálva Logicom
- nincs kategorizálva Peach
- nincs kategorizálva Moulinex
- nincs kategorizálva Wilson
- nincs kategorizálva Kwantum
- nincs kategorizálva Nofred
- nincs kategorizálva Mercusys
- nincs kategorizálva GoClever
- nincs kategorizálva Avid
- nincs kategorizálva Soundsphere
- nincs kategorizálva COLBOR
- nincs kategorizálva Strymon
- nincs kategorizálva Cablexpert
- nincs kategorizálva Ashdown Engineering
- nincs kategorizálva Salter
Legújabb útmutatók nincs kategorizálva
10 Április 2025
10 Április 2025
10 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025