Használati útmutató IFM IG3505

Olvassa el alább 📖 a magyar nyelvű használati útmutatót IFM IG3505 (1 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 11 ember találta hasznosnak.

ifm electronic gmbh • Friedrichstraße 1 • 45128 Essen • Germany • http://www.ifm.com • e-mail:info@ifm.com

UK

80011315 / 00 05 / 2014

Mounting Instructions

Flush mountable tubular switches / CSA Div. 2

Flush mountable switches can be mounted so that the ac-

tive face is flush with a metal surface. Any metal in front

of the switch should be kept at a distance of three times

the nominal sensing range.

s= nominal sensing range

b= maximum thread length

M8 - 8 mm, M12 - 8 mm

M18 - 8 mm, M30 - 16 mm

3xs

b

Two flat nuts are provided to hold the installed switch in

place.

When mounting tubular switches opposite each other, the spacing distance

shown here should be maintained.

Sr = nominal sensing range

8 xSr

active face

When mounting tubular switches next to each other, the spacing distance

shown here should be maintained.

D =switch diameter

D

DD

active face

active face

CSA for Hazardous Locations

When wired in accordance with CEC and this mounting instructions.

Class I, Div. 2, Groups A, B, C and D

Class II, Div. 2, Groups E, F and G

Class III, T4

Enclosure: Type 4/4x

Temp. range: -13° to 176°F (-25° to 80°C)

ELECTRICAL

DO NOT operate an incandescent light bulb as a load.

The current inrush when the bulb is cold can cause a

current overload.

DO NOT operate a proximity sensor directly from a

voltage supply without a load. This is a short circuit and

can cause damage. Note: insert a miniature fuse accor-

ding to the technical data sheet, if specified.

Concerning Safety...ifm efector makes every effort to build a de-

pendable product, but every product will eventually fail. Therefore,

your equipment must be designed to prevent property damage

and personal injury if our products fail. ifm efector proximity

switches are not designed to be used as stand-alone devices to

protect or guard human life or limb.

WARNING

Explosion Hazard – substitution of components may impair suitability

of Class 1, Div. 2. Do not disconnect while circuit is live unless area is

known to be non-hazardous.

AVERTISSEMENT

Risque d'explosion - La Substitution de composants peut rendre ce

matérielle inacceptable pour les emplacements de classe I division 2.

Ne pas débrancher tant que le circuit est sous tensions, à moins qu'il

ne s'agisse d'un emplacement non dangereux.

CAUTION

Use only ifm efector conduit adapters (U30029, U30030, U30031) or

other CSA ceritifed conduit adapters.

ATTENTION

Utiliser uniquement les adaptateurs tube d'ifm efector (U30029,

U30030, U30031) ou d'autres adaptateurs tube certifiés par CSA.

Termékspecifikációk