Használati útmutató Jung ENOAL299

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Jung ENOAL299 (5 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 11 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.9 csillagra

Oldal 1/5
EnOcean radio transmitter
05.03.20211 / 50024000901
EnOcean radio transmitter
Ref.-no.: ENO A 590 .., ENO LS 990 ..
ENO A 595 .., ENO LS 995 ..
Operating instructions
1 Safety instructions
Electrical devices may only be mounted and connected by electrically skilled persons.
Serious injuries, re or property damage possible. Please read and follow manual fully.
The radio communication takes place via a non-exclusively available transmission path, and is therefore not
suitable for safety-related applications, such as emergency stop and emergency call.
These instructions are an integral part of the product and must remain with the end customer.
2 Device components
Fig. 1: Device components
(1) Adhesive pad
(2) Holder plate
(3) Frames (not included in delivery)
(4) Radio module
(5) Rockers
(6) Retaining screw
Fig. 2 and g. 3: Transport lock and protective lm
(7) Transport lock for rockers
(8) Protective lm for holder plate
1
6
23
4
5
8
7
GB
EnOcean radio transmitter
05.03.20213 / 50024000901
Adhesive xing
Important:
The nal strength of the adhesive is only reached after 24 hours.
After gluing the holder plate, let the adhesive cure a little.
Important:
The installation location cannot be changed after the adhesive xing.
To test the range, carry out commissioning before adhesive xing.
Prerequisite:
Surface is dry, clean, stable and even.
Suitable cleaning agents:
water, degreaser, glass cleaner, methylated spirit
Not suitable for cleaning:
Bath or all-purpose cleaner, aggressive detergents
Remove the protective lm from the back of the adhesive pad (1).
Stick the adhesive pad aligned on the surface.
Press rmly for about 10 seconds.
Remove the protective lm (8) for the holder plate (2).
Do not remove the remaining protective lms.
Stick the holder plate onto the adhesive pad.
5 Operation
Fig. 5: Operation
Operating elements
The radio transmitter is operated either via one rocker (2-channel) or via two rockers (4-channel). There are four
push-buttons (9) under the rockers. The push-buttons are grouped into two channels (A and B). A distinction is made
between two states (I and O) for each channel.
The functions of the rockers (switching, push-button, dimming or blind) are not congured in the factory settings of the
device.
Factory settings/Reset
Restoring factory settings:
Remove rockers (5) carefully with a suitable tool (e.g. button lever).
Press all four push-buttons (9) and press the activation bar (10) simultaneously 7 x.
Factory settings are restored automatically.
The radio transmitter is no longer taught-in.
Rockers are without function.
Snap rockers on again.
10
9
9
9
9

Termékspecifikációk

Márka: Jung
Kategória: nincs kategorizálva
Modell: ENOAL299

Szüksége van segítségre?

Ha segítségre van szüksége Jung ENOAL299, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek