Használati útmutató Kenwood NXR-5800

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Kenwood NXR-5800 (16 oldal) a Rádiókommunikáció kategóriában. Ezt az útmutatót 11 ember találta hasznosnak.

/ 16 PDF

1

UNPACKING AND CHECKING EQUIPMENT

Note:The following unpacking information is for use by your

KENWOOD dealer, an authorized KENWOOD service center, or the

factory.

Carefully unpack the repeater. We recommend that you identify

the items listed in the following table before discarding the

packing material. If any items are missing or have been damaged

during shipment, file a claim with the carrier immediately.

ItemPart NumberQuantity

Front glassB10-2781-XX1

Dressed screwN08-0563-XX1

BracketJ29-0725-XX2

Flat head machine screwN32-4008-XX4

HandleK01-0421-XX1

DC cordE30-3427-XX1

Lead wire with connector (15 pin)E31-3228-XX1

Fuse (15 A)F52-0042-XX1

SYNC cableE3A-0177-XX1

Instruction manualB5A-0714-XX1

INSTALLATION

To install the handles onto the front panel of the repeater, align

the handles with the holes on the front panel, then secure the

handles using the supplied screws.

Consult your dealer for installing the repeater and antenna.

MICROPHONE

Connect an optional KMC-30, KMC-35, KMC-9C, or KMC-53

KENWOOD microphone to the MICROPHONE jack on the front

panel.

OCXO UNIT (KXK-3): Option

The OCXO unit (KXK-3) is an Oven Controlled Crystal Oscillator

(OCXO) unit.

NOTICES TO THE USER

◆

Government law prohibits the operation of unlicensed radio

transmitters within the territories under government control.

◆

Illegal oper

ation is punishable by fine and/or imprisonment.

◆

Ref

er service to qualified technicians only.

◆

This repeater is intended for use as a fixed base station with

the antenna located outdoors on the rooftop or on an antenna

tower.

◆

This repeater is designed f

or a 13.2 V DC power source.

Never use a 24 V DC or higher source to power the repeater.

◆

Use only the supplied DC cord.

◆

Do not remo

ve the ferrite core attached to the DC cord. Doing

so may cause interference with radio communications.

◆

Do not put anything on top of the repeater. This will obstruct

heat dissipation.

THANK YOU!

We are grateful you purchased this KENWOOD repeater.

PRECAUTIONS

•Donotexposetheunittorainormoisture;topreventreor

electr

ic shock.

•Donotopentheunitunderanycircumstances;



toavoidrisk

of electr

ic shock.

•Donotexposetheunittolongperiodsofdirectsunlight,nor

place it close to heating appliances

.

•Donotplacetheunitinexcessivelydustyand/orhumid

areas, nor on unstable surfaces.

•Donotputtheplasticbagusedforpackingofthisequipment

on the place which reaches a small child's hand.

It will

become a cause of suffocation if it wears flatly.

•Alwaysswitchthetransceiverpoweroffbeforeinstalling

optional accessor

ies.

•Ifyoudetectanabnormalodororsmokecomingfromthe

unit, disconnect the power from the unit immediately. Contact

your KENWOOD service center or dealer.

B5A-0714-30 (E)

VHF DIGITAL BASE-REPEATER/ UHF DIGITAL BASE-REPEATER

INSTRUCTION MANUAL

NXR-5700/ NXR-5800

◆

Do not install the repeater in explosive atmospheres

(inflammable gas, dust particles, metallic powders, grain

powders, etc.).

Information on Disposal of Old Electrical and Electronic Equipment and Batteries

(applicable for countries that have adopted separate waste collection systems)

Products and batteries with the symbol (crossed-out wheeled bin)

cannot be disposed as household waste.

Old electrical and electronic equipment and batteries should be

recycled at a facility capable of handling these items and their waste

byproducts.

Contact your local authority for details in locating a recycle facility

nearest to you.

Proper recycling and waste disposal will help conserve resources

whilst preventing detrimental effects on our health and the environment.

The AMBE+2

TM

voice coding Technology embodied in this product is protected

by intellectual property rights including patent rights, copyrights and trade

secrets of Digital Voice Systems, Inc. This voice coding Technology is

licensed solely for use within this Communications Equipment. The user of

this Technology is explicitly prohibited from attempting to extract, remove,

decompile, reverse engineer, or disassemble the Object Code, or in any other

way convert the Object Code into a human-readable form. U.S. Patent Nos.

#8,315,860, #8,595,002, #6,912,495, #8,200,497, #7,970,606, and #8,359,197.

© 2019

NOTIFICATION

This equipment complies with the essential requirements of Directive

2014/53/EU.

RESTRICTIONS

This equipment requires a licence and is intended for use in the countries

as below.

ATBEDKFIFRDEGRISIE

ITLILUNLNOPTESSECH

GBCYCZEEHULVLTMTPL

SKSIBGROHRTR

ISO3166

ModelFrequency rangeMax. output power

NXR-5700-ETX/RX136.000 - 174.000 MHz25 W

NXR-5800-ETX/RX400.000 - 470.000 MHz25 W

Firmware Copyrights

ThetitletoandownershipofcopyrightsforrmwareembeddedinKENWOOD

productmemoriesarereservedforJVCKENWOODCorporation.

Termékspecifikációk