Használati útmutató Netgear ProSafe AXM763

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Netgear ProSafe AXM763 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.6 csillagra

Installation Guide

e

ProSafe 10 Gigabit Base-LRM SFP+ Module AXM763

Install Your Optical Module

The 10G Base-LRM SFP+ module provides a full-duplex 10G bps each direction for

Ethernet operation on NETGEAR managed switches.

The switch will automatically detect the AXM763, so you can simply plug it into an

available module slot.

The module can be inserted or removed while the switch is operational.

AXM763

Installing a AXM763 Module

Insert the module firmly into the slot that supports the SFP+ interface. Make sure the

optical cable you use is multi-mode LC to LC duplex cable.

Removing a AXM763 Module

Release the module latch by pulling down the handle bar across the module, and pull

the module out of the module slot.

Table 1:

Technical Specications

StandardsIEEE 802.3aq 10GBase-LRM

Wavelength1310nm

Dimensions (HxWxD)0.46” x 0.53” x 2.19”

(11.9 mm x 13.7 mm x 55.7 mm)

Weight0.018kg

Operating Temperature23 -158º F (-5 - 70ºC)

Storage Temperature-40 -185 ºF (-40 - 85ºC)

Operative relative humidity85% @ (25ºC)

Operating DistanceUp to 220m for the following multi-mode optical fiber

(MMF):

62.5/125µm (OM1) multi-mode fiber,

50/125µm (OM2) multi-mode fiber,

50/125µm (OM3) multi-mode fiber ‘laser optimized’

ConnectorsLC

Power Consumption<1.5w

MTBF966,837 hr(110 years)

Safety CertificationUL 1950 CSA 22.2 No. 950

Environmental ComplianceRoHS

Termékspecifikációk