Használati útmutató PAC RP4-NI11

Olvassa el alább 📖 a magyar nyelvű használati útmutatót PAC RP4-NI11 (9 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 14 ember találta hasznosnak.

/ 9 PDF

RP4-NI11

Radio Replacement & Steering Wheel Control Interface

for Nissan Vehicles

Pacic Accessory Corporation

®

| Ph. 866-931-8021 | support@pac-audio.com

©2016 Pacic Accessory Corporation

www.pac-audio.com

Rev. 011116

C

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the

interface into the vehicle (see next page for setting chart).

2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless

you wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always

be restored to default settings by pressing and releasing the program button on the side of the interface once and waiting 7

seconds for the LED to ash 4 times.

3. Does not retain 360 camera system

4. In some 2014+ Nissan Rogues, it may be necessary to nd an alternate accesory 12v+ wire If the interface and aftermarket

radio are not powering up. Please see Appendix A on page 4 to nd an alternate accessory 12v+ wire.

Vehicle Connector

SWC Connector

SWC Connection

See above chart for

different radio type

connections

Acc On/

Programming

LED

Programming

Button

WiringSWC Connection

YellowBattery +12v

BlackGround

RedAccessory 12v+

Purple / WhiteVehicle Speed

Output

Blue / WhiteAmp Turn On Input

Orange / WhiteIllumination Output

(+)

Green*Reverse Output (+)

WhiteFront L + input

White / BlackFront L - input

GreyFront R + input

Grey / BlackFront R - input

GreenRear L + input

Green / BlackRear L - input

PurpleRear R + input

Purple / BlackRear R - input

Yellow RCA*Reverse Camera

Output

Blu/YelKenwwod, Newer

JVC

3.5mm JackAlpine, JVC,

Clarion, Fusion,

Pioneer, Sony,

Boyo, Dual,

Lightning Audio,

Visteon or Advent

The RP4-NI11 interface allows the replacement of a factory radio in select Nissan vehicles with MSCAN databus radios.

Using this interface will retain factory features such as steering wheel controls (SWC), reverse camera and the factory

amplier when the original radio is removed. Use of this interface also allows you to program two radio functions to each

SWC button by using short press long press dual command functionality. The RP4-NI11 also provides outputs such as

vehicle speed sensor (VSS), illumination and *reverse trigger.

* Only available in vehicles

equipped with a factory reverse

camera.

Cut for Non-Bose systems

Aftermarket Radio Connections

See above chart for wire color

description.

Termékspecifikációk