Használati útmutató PAC RP5-GM31

Olvassa el alább 📖 a magyar nyelvű használati útmutatót PAC RP5-GM31 (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 19 ember találta hasznosnak.

Radio Replacement & Steering Wheel Control Interface

with OnStar Retention for General Motors Vehicles

C

Rev. 092617Page 1

© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.

PAC-audio.com

RP5-GM31

Introduction & Features

Important Notes

Wiring Connection Chart

Illustration / Schematic

The RP5-GM31 interface allows the replacement of a factory radio in select General Motors vehicles with 29-bit LAN

radios. Using this interface will retain factory features such as OnStar, steering wheel controls (SWC), warning chimes,

5HDU6HDW&RQWUROV56&IDFWRU\;05DGLRDQGWKH%26(DPSOL¿HUZKHQWKHRULJLQDOUDGLRLVUHPRYHG8VHRIWKLV

interface also allows you to program two radio functions to each SWC button by using short press long press dual

command functionality. The RP5-GM31 also provides data bus driven outputs such as retained accessory power (RAP),

vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.

1. These instructions only apply to R.2.6.6.17 or later revisions. The revision info can be found on a small white sticker on the

interface and packaging.

2. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the

interface into the vehicle (see next page for setting chart).

3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless

you wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always be

restored to default settings by following the procedure outlined on page 3.

4. RSC buttons that are identical to the SWC will mimic the SWC one for one.

5. 7KH/('ZLOOÀDVKZKHQHYHUD6:&EXWWRQLVSUHVVHG

Light GreenParking Brake Output (-)

PinkVehicle Speed Output

BlueNot Used

Blue / WhiteAmp Turn On Input

Orange / WhiteIllumination Output (+)

Purple / WhiteReverse Output (+)

Brown LoopMute Loop - See

installation note 8.

Aftermarket Radio Connections

Yellow *+12v from RP5

Yellow *+12v from vehicle

Black **Ground from RP5

Black **Ground from vehicle

RedAcc. Output

WhiteFront Left + input

White / BlackFront Left - input

GreyFront Right + input

Grey / BlackFront Right - input

GreenRear Left + input

Green / BlackRear Left - input

PurpleRear Right + input

Purple / BlackRear Right - input

SWC Connector

Blue / YellowKenwood, Newer JVC

3.5mm Jack

Alpine, JVC, Clarion,

Pioneer, Sony, Fusion,

Boyo, Dual, Lightning

Audio, Visteon or

Advent

SWC Connection

See above chart for

different radio type

connections

WiringSWC Connection

XM R

XM L

Aftermarket

Radio

Connections

Vehicle

Connections

IMPORTANT NOTES REGARDING YELLOW AND BLACK WIRE CONNECTIONS

* Connect both Yellow wires from the

RP5 harnesses to the radios 12v

constant input.

** Connect both Black wires from the

RP5 harnesses to the radios ground

input.

Termékspecifikációk