Használati útmutató Panduit CT-2500CHR

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Panduit CT-2500CHR (18 oldal) a Akkumulátor töltő kategóriában. Ezt az útmutatót 15 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.5 csillagra

Page: 1 of 2

CT-2500BC,CT-2500CHR

and CT-2500CHR/E

PA25384A01

Rev. 011- 2014

BATTERY CARTRIDGE AND BATTERY CHARGER

USED WITH THE CT-2500 and CT-2500/E TOOLS

OPERATION INSTRUCTIONS

© Panduit Corp. 2014

USE OF THE BATTERY CARTRIDGE AND CHARGING UNIT

The chargingunit is run with a nominal voltage of 120 V (CT2500CHR), or (230 V for -

CT--2500CHR/E) and a frequency of 5060 Hz. New batteries must be charged prior to use. To

remove the battery, actuate the battery lock and pull it out of the tool. To charge the battery,

connect the power plug of the charging unit with the power supply and slide the battery into the

charging unit. The charging time is 40 minutes. The charging level of the battery cartridge can be

checked by the right LED (multicolor) of the charging unit.-

Left LED (Red)Right LED (Multi -color)

Red Charging unit ready to operateBattery defective

Red Flashing

Charging unit out of order.

New or unused batteries whose

nominal capacity is not sufficient.

Battery too hot or too cold.

Remove battery.

Safety components possibly defective.

Green – Charging cycle starts

Green Flashing –

Battery fully charged.

Charging unit switches automatically into a

maintaining mode. Battery can stay in charger

for indefinite time w/o being damaged.

Yellow

–

Battery at least 90% charged.

Charging cycle can be terminated.

– If the right LED does not light up, the circuit of

the battery is disconnected or the battery is

incorrectly polarized.

•If the nominal capacity of the battery is not achieved, e.g. at first charge, the battery is not

necessarily faulty. Full capacity can be achieved after (3) charging/discharging cycles.

•When the speed of the tool decreases noticeably, the battery must be recharged.

ATTENTION:

Do Not recharge a partially discharged battery as a precaution.

•Charge the battery at room temperature between 50°F and 104°F (10°C and 40°C).

•Charging batteries at low temperatures, under 41°F (5°C) is not possible. Increase battery

temperature before starting the charging cycle.

•Do Not expose the charging unit to rain or snow.

•Do Not charge a battery in the vicinity of explosive materials and gases.

•No other batteries (e.g. dry batteries or car batteries, etc.) are to be used in the tool or in the

charging unit.

•Do Not use the cord to transport the charging unit, or to pull the plug out of a wall socket with

force.

•Do Not insert foreign objects into the ducts of the charging unit. Pull the plug of the charging

unit after charging. Do Not disassemble the charging unit or battery.

Termékspecifikációk