Használati útmutató RC4WD VVV-S0009

Olvassa el alább 📖 a magyar nyelvű használati útmutatót RC4WD VVV-S0009 (5 oldal) a Rádióvezérlésű játékok kategóriában. Ezt az útmutatót 18 ember találta hasznosnak és 4 felhasználó értékelte átlagosan 4.0 csillagra

Speed Controller

Programming Instructions

20A/30A/40A/45A/60A/70A/80A/100A/125A/200A

Phrases 1 Enter programming Mode

1.Connect your motor and receiver to the speed controller, but do not connect the

battery yet.

2.Turn on your transmitter and move the throttle stick to the full throttle position (full

up). Please Note: Most Futaba transmitters have the throttle channel reversed by

default.

3.Connect your battery and the controller will initialize with a musical tone.

Phrases 2 Programming

After 3 seconds, the controller will start beeping a sequence of tones – a musical tone

followed by one or more beeps. Each sequence represents a parameter that you can program

and is repeated 3 times. The parameters are:

—Tone + 1 BeepCell Type and No. of Cells

— . —Tone + 2 BeepsThrottle Setting

— . — . —Tone + 3 BeepsBrake Setting /Throttle type (for Heli)

— — — — Tone + 4 BeepsDirection and Cutoff Type

— — — — —Tone + 5 BeepsTiming Mode

— — — — — —Tone + 6 BeepsPulse Width Modulation (PWM)

Step 1. Starting. When you hear the sequence for the parameter you wish to program, move the

throttle stick to the center position.

The controller will then start beeping aMorse code sequence of short and long beeps

representing the possible options you may choose for the selected parameter. See table 2 for

a list of all programmable options. Each option sequence is repeated 3 times.

Step 2. Select and save, the select the option, move the throttle stick back to the full up

position., When you hear the sequence for the option you wish to select. The controller will

then save the selected option, andsound a long beep as a confirmation. It then goes back

to the beginning of the programming sequence (phrases 2 step 1).

Step 3. Complete programming and save options. Setup all the parameters you need to change.

When complete, move the throttle stick to the lowest (down) position. The controller will

save all options and re-initialize in normal running mode so you can start your motor.

Termékspecifikációk