Használati útmutató Roland FC-300

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Roland FC-300 (6 oldal) a hi-fi rendszer kategóriában. Ezt az útmutatót 16 ember találta hasznosnak.

/ 6 PDF

1

FC-300, GT-PRO

Using the FC-300 and GT-PRO in Combination

What You Can Do with the FC-300 and GT-PRO in Combination

You can accomplish GT-PRO patch changes.

After you’ve finished doing the tasks in “Making the Settings for the FC-300 (Getting Ready for Use In Combination),” read “Switching GT-

PRO Patches on the FC-300” (p. 2).

You can carry out GT-PRO Manual Mode operations.

After you’ve finished doing the tasks in “Making the Settings for the FC-300 (Getting Ready for Use In Combination),” read “Switching the

Effect On and Off with the FC-300’s Pedals (Manual Mode)” (p. 4).

You can control the GT-PRO using the FC-300’s CTL and EXP pedals.

Read “Controlling the GT-PRO with the FC-300’s CTL/EXP Pedal” (p. 6).

Making the Settings for the FC-300 (Getting Ready for Use In

Combination)

Limiting the Range of Banks That Can Be Switched (Bank Extent)

1. In the FC-300’s top screen, press [UTILITY].

2. Press PARAMETER [] [] to display the following screen.

3. Press VALUE [▼] [▲] to select “EFFECTS.”

4. Press PARAMETER [] [] to display the following screen.

5. Press VALUE [▼] [▲] to make the setting for 1 through 40.

Sets the upper limit for banks that can be switched when banks are specified with the FC-300’s [▼] [▲] pedals.

6. Press [EXIT] to return to the top screen.

Setting the Timing for Switching Patches (Bank Change Mode)

1. In the FC-300’s top screen, press [UTILITY].

2. Press PARAMETER [] [] to display the following screen.

3. Press VALUE [▼] [▲] to specify the parameter.

4. Press [EXIT] to return to the top screen.

SYS:PC Mode

‚ EFFECTS„

SYS:Bank Extent

‚ 40„

SYS:Bnk Chg Mode

‚ IMMEDIATE„

Parameter Explanation

IMMEDIATEProgram changes are transmitted immediately when [▼] [▲] or each number pedals are pressed.

Example) When starting from “003,” pressing [▲] simultaneously transmits PC#8.

WAIT FOR A NUMProgram changes are transmitted when a number pedal is pressed after [▼] or [▲] is pressed.

Example) Starting from “003,” after [▲] is pressed and all of the green number pedal indicators

are flashing, pressing number pedal 8 outputs PC#8.

©2008 BOSS CORPORATION

All rights reserved. No part of this publication may be reproduced in any form without the written

permission of BOSS CORPORATION.

Termékspecifikációk