Használati útmutató AIM Sportline Multichron

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AIM Sportline Multichron (3 oldal) a Különféle kategóriában. Ezt az útmutatót 16 ember találta hasznosnak.

Release 1.04

Aim s.r.l. Via Cavalcanti 8, 20063 Cernusco sul Naviglio – MI – ITALY

Tel (+39) – 02- 9290571 . Fax (+39) – 02 – 92118024 www.aim-sportline.com

1)Initial set up When you first use the Multichron, press the CONF-SPEED button to set the following options (press the plus or

minus buttons to vary the settings and then press the DATA-STOP button to move to the next line):

i)Contrast (to alter the display and viewing angle)

ii)Light on/off (for versions with backlight)

iii)Beep sound on/off

iv)Send (IRDA) PC transmission data (see PC data section)

v)Econ on/off (Power saver, when “on” the display closes down until a button is pressed.

Press the CONF-SPEED button to move to the next set up screen:

vi)Alarm on/off

vii)Set the time when the alarm will go off (use the DATA-STOP button to choose the hours and minutes to change. Change

the flashing digit by using the plus or minus button.

viii)Chime on/off (when “on” the multichron beeps every 30 minutes)

ix)Time of day: Use the same button logic as in vii) above to set the correct time of day. The default setting is 12 hour mode.

You can change this from A (am) to P (pm) or _ (24 hour mode)

Press the CONF-SPEED button to move to the next set up screen:

x)Distance measurement ( you can choose between Miles or Kilometers

Competitor 2,3 and 4

previous lap/current lap

times

Competitor 1 previous lap

time

Competitor 1 current lap

running time.

Lap number

Number in SPL

column shows the

number of split

times per lap. A b

in this column

denotes best time

Use – set + when configuring your required

settings

For competitor

1,2,3 and 4 timing

IR PC Data Transmission system

Termékspecifikációk