Használati útmutató APC RBC9
Oldalak 2 Engels UPS
Olvassa el ingyen online a(z) APC RBC9 használati útmutatóját, vagy töltse le PDF-ben. Az útmutatót 23 ember találta hasznosnak. Kérdése van a modellről? Tegyen fel kérdést
990-0374A revision 2 11/01
This adendum does not apply to Bak-UPS Po 1000/1400 and Smart-UPSV/S 1000/1400dcr
I.Installation
Follow the installation illustration on the accompanying sheet.
Note: Small sparks at the battery connectors are normal during connection.
II.Post-Installation
Once installed,
allow the unit to charge for five hours. If the unit is an XL model, allow it to charge for
24 hours.
Note:The Smart-UPS will charge whether it is on or off, and will charge whether there is a load
present or not. In situations where the power quality is poor, it is recommended that the unit be
shutdown during this charging period. A Smart-UPS that is powered on may switch to battery
operation which would prolong the time needed to fully recharge the battery.
III. Clearing the Replace Battery LED
A.In order for the replace battery LEDvalidto be cleared, it is necessary to run a self test. For a self test
to be considered valid, the following conditions must be satisfied:
■battery capacity must be greater than 75%(minimum of four battery bar graph LEDs illuminated)
or
■Smart-UPS must have been charging for at least 8 hours from the last low battery condition. (Low
battery condition refers to a state when the Smart-UPS battery has fully discharged).
B.Ways to initiate a self test
A self test can be initiated in any one of five ways:
■Start up of the UPS
■Smart-UPS front panel test button
■Powerchute PLUS software
■SmartSlot Accessory
■Automatic timer- every two weeks from turn on (see APC owners manuals for details)
IV. Verifying Operation
A.What happens during a self test?
When a self test is initiated, the unit supports the load while operating on battery for approximately
8-10 seconds. During this period, the Smart-UPS determines the health of the battery.
B.When should the self test be performed?
After the unit has charged for five hours, a self test can be performed.
Replacement Battery Cartridge(RBC) Addendum
RBC5, RBC6, RBC7, RBC8, RBC9, RBC11, RBC12, RBC22, RBC23, RBC24, RBC25,
RBC27, RBC28, RBC5I, RBC6I, RBC7I, RBC8I, RBC9I, RBC11I, RBC12I, RBC22I,
RBC23I, RBC24I, RBC25I, RBC5J, RBC6J, RBC7J, RBC8J, RBC11J, RBC12J,
Termékspecifikációk
| Márka: | APC |
| Kategória: | UPS |
| Modell: | RBC9 |
Szüksége van segítségre?
Ha segítségre van szüksége APC RBC9, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók UPS APC
APC Galaxy VS GVSOPT026 Útmutató APC Smart 1500VA Útmutató APC AP9626 Útmutató APC RBC22 Útmutató APC SUVTR40KH5B5S Útmutató APC ISXT15MD1RI Útmutató APC Smart-UPS 3000VA Útmutató APC MGE Galaxy 3500 20kVA 400V Útmutató
Összes APC UPS használati útmutató
Népszerű termékek – UPS
Útmutatók UPS
Legújabb útmutatók UPS
CyberPower OLS1500EXL Útmutató CyberPower OLS3000ERTXL2U Útmutató CyberPower Value600EI Útmutató CyberPower SE450G1 Útmutató CyberPower MBP63AHVHW82U Útmutató CyberPower OLS2000ERT2UA Útmutató CyberPower OLS6000E Útmutató CyberPower UT850EG Útmutató CyberPower PR2200LCDRTXL2UTAA Útmutató CyberPower PR1500LCDRTXL2UTAA Útmutató