Használati útmutató Aruba 7005
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Aruba 7005 (2 oldal) a vezérlő kategóriában. Ezt az útmutatót 23 ember találta hasznosnak és 12 felhasználó értékelte átlagosan 4.8 csillagra
Oldal 1/2
Aruba 7005 Controller
The Aruba 7005 Controller is a wireless LAN controller that connects, controls,
and intelligently integrates wireless Access Points (APs) and Air Monitors (AMs)
into a wired LAN system. The 7005 controller includes four ethernet ports, one
Console port, one Mini-USB console port, and one USB port. This device
supports up to 16 APs and 1024 users.
Package Contents
Aruba 7005 Controller
Mini-USB Console Cable
Installation Guide (this document, printed)
Quick Start Guide (Printed)
End User License Agreement (Printed)
7005 Components
This section introduces the different components and their location in the Aruba
7005 controller. Figure 1 shows the front panel of the Aruba 7005 controller and
Figure 2 shows the back panel of the Aruba 7005 controller.
Figure 1 Front Panel of the 7005 Controller
Figure 2 Back Panel of the 7005 Controller
Ethernet Ports
The Aruba 7005 controller is equipped with four 10/100/ 1000BASE-T Gigabit
Ethernet ports (0 to 3). Gigabit Ethernet uses all eight wires and each pair is bi-
directional, which means, the same pair is used for both data transmission and
data reception. Figure 3 illustrates the Gigabit Ethernet port pin-out for an RJ-45
connector. The pins paired on a 10/100/1000BASE-T Gigabit Ethernet port are: 1/
2, 3/6, 4/5, and 7/8.
Figure 3 Gigabit Ethernet Port Pin-Out
Ethernet Port LEDs
Each 10/100/1000BASE-T Ethernet port is equipped with two LEDs that allow
basic monitoring of link/port status and activity.
LINK/ACT: Placed on the left side of the port, this LED displays the link
status and activity of the port.
STATUS: Placed on the right side of the port, this LED displays the status of
the port based on the CLI.
The following table describes the LED behavior for each mode:
Console Port
The serial console port allows connecting the controller to a serial terminal or a
laptop for direct local management. This port is an RJ-45 female connector with
the pinouts described in Figure 4. Connect it directly to a terminal or terminal
server using an Ethernet cable.
Figure 4 Serial Console Port Pin-Out
The communication settings for the Console port is shown in the following table:
Serial Console Port Adaptor
A modular adaptor can be used to convert the female RJ-45 connector to a male
DB9 connector. See Figure 5 for complete details.
Figure 5 RJ-45 (Female) to DB9 (Male) Modular Adapter Conversion
Mini-USB Console Connector
The Aruba 7005 controller is equipped with one Mini-USB (type B) connector
that provides console access for direct local access. If both Mini-USB and RJ-45
Console ports are connected, the Mini-USB connection takes precedence over
the RJ-45 Console connection.
Mini-USB Driver
To use the Mini-USB console port, install the Aruba Mini-USB driver on the
computer that will manage your controller. To download the driver, perform the
following steps:
1. Go to https://support.arubanetworks.com.
2. Click on the Tools & Resources tab.
3. Open the USB Console Driver folder.
4. Open the Mobility Controller and Mobility Access Switch folder.
5. Select the appropriate file for your application. The corresponding operating
system is in the file name.
USB Interface
The Aruba 7005 controller is equipped with one USB 2.0 interface. A USB storage
device can be used to save and upload configurations to the controller.
Power and Status LEDs
The front panel also includes power and status LEDs that provide basic
monitoring of the overall status of the Aruba 7005 controller
Kensington Security Slot
The Aruba 7005 controller is equipped with a Kensington security slot for
additional security.
DC Power Socket
The AC-DC adapter kit with the following specification is used to power the
Aruba 7005 controller:
12V/ 2A power interface
Center-positive 1.7/4.0 mm circular plug, 9.5 mm length
Make sure to securely route the DC cable through the slot provided. See
Figure 6.
Figure 6 DC Cable Routing Slot
Installing the 7005 Controller
Installation Recommendations
For proper air circulation, leave at least 10 cm (4 inches) clearance for the
vents on the left, right, front, and rear side of the controller.
Leave additional space in front and rear side of the controller to access
power cords, network cables, and indicator LEDs.
Avoid placing anything that covers the vents on top of the controller.
Covering the vents can lead to overheating of the controller.
Avoid placing this controller on any other device because the heat dissipated
from the other device may overheat the controller.
Installation Using the Integrated Wall-Mounting Slots
The keyhole-shaped slots on the bottom of the controller can be used to attach
the device upright (front port facing downwards) to an indoor wall or shelf.
Since the ports are on the front of the device, make sure to mount the controller
in such a way that there is a clear path to the Ethernet port, such as a predrilled
hole in the mounting surface.
1. At the mounting location, install two screws on the wall or shelf, 120 mm
apart. If you are attaching the device to drywall, it is recommended that you
use appropriate wall anchors (not included). See Figure 7.
Figure 7 Mounting Using the Integrated Wall-Mounting Slots
2. Align the mounting slots on the bottom of the controller over the screws and
slide the unit into place. See Figure 8
Figure 8 Wall Mounting Aruba 7005
Product Specifications
Physical
Device Dimensions (HxWxD): 4.09 cm x 20 cm x 20 cm
Device Weight: 2.03 lbs (0.92 kg)
Electrical
Ethernet:
4 x 10/100/1000BASE-T auto-sensing Ethernet RJ-45 Interfaces
MDI/MDX
Power over Ethernet (IEEE 802.3af or IEEE 802.3at compliant), 48V DC
(nominal) and 56V DC (maximum)/ 350 mA (see Figure 3 for pin
configuration)
The 7005 controller requires ArubaOS 6.4.1.0 or later.
Optional accessories are available for use with the Aruba 7005 controller and
are sold separately. Contact your Aruba sales representative for details and
assistance.
In the Aruba 7005 controller, the orange numbering on port 0 indicates that
it is a PoE powered device (PoE-PD) port and the gray numbering on ports
1, 2, and 3 indicate that they are non-PoE ports.
1000Base-T Gigabit
Ethernet Port
RJ-45 Female
Pin-Out
Signal Name
1
2
3
4
5
6
7
8
BI_DC+
BI_DC-
BI_DD+
BI_DD-
BI_DA+
BI_DA-
BI_DB+
BI_DB-
Function
Bi-directional pair +C
Bi-directional pair -C
Bi-directional pair +D
Bi-directional pair -D
Bi-directional pair +A
Bi-directional pair -A
Bi-directional pair +B
Bi-directional pair -B
Table 1 10/100/1000BASE-T Ethernet Port LEDs
LED Function Mode Indicator Status
LINK/ACT Link status N/A Green (Solid) Link has been
established
Green (Blinking) Port is transmitting or
receiving data
Off No link on port
STATUS Port status Speed Green (Solid) 1000 Mbps
Off 10/100 Mbps
Table 2 Console Terminal Settings
Baud Rate Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None
!
!
!
!!
CAUTION
The CONSOLE port is compatible only with RS-232 devices. Non-RS-232
devices, such as APs, are not supported.
!
!
!
!!
CAUTION
Do not connect the Console port to an Ethernet switch or a PoE power
source. This may damage the controller.
Serial
Console Port
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
Direction
Input
Output
GND
3
4
5
2
5
6 3
RJ-45 DB-9
Internal
Connections
TxD
GND
RxD
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
DB-9 Male
Pin-Out
TxD
RxD
Ground5
4
3
2
1
9
8
7
6
If the 7005 controller is powered from IEEE 802.3at PSE then the USB port
remains enabled. If the 7005 controller is powered from IEEE 802.3af PSE,
then the USB port is automatically disabled.
Table 3 Power and Status LEDs
LED Function Indicator Status
Power System powers Green (Solid) Powered from DC adapter
Amber (Solid) Powered from PoE source
Off Power Off
Status System status Green (Solid) Operational
Green (Blinking) Device is loading software
Amber (Blinking) Major Alarm
Amber (Solid) Critical Alarm
Off No power
Service to all Aruba Networks, Inc. products should be performed by trained
service personnel only.
Termékspecifikációk
| Márka: | Aruba |
| Kategória: | vezérlő |
| Modell: | 7005 |
Szüksége van segítségre?
Ha segítségre van szüksége Aruba 7005, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók vezérlő Aruba
28 Szeptember 2024
31 Július 2024
30 Július 2024
27 Július 2024
22 Július 2024
15 Július 2024
14 Július 2024
11 Július 2024
8 Július 2024
8 Július 2024
Útmutatók vezérlő
- vezérlő Leviton
- vezérlő Savio
- vezérlő Steelseries
- vezérlő Vivanco
- vezérlő Adj
- vezérlő RiotPWR
- vezérlő Senal
- vezérlő Kanlux
- vezérlő Tascam
- vezérlő Bosch
- vezérlő Saramonic
- vezérlő Mitsubishi
- vezérlő Garmin
- vezérlő Radial Engineering
- vezérlő Nyko
Legújabb útmutatók vezérlő
2 Április 2025
30 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025
30 Március 2025
28 Március 2025
27 Március 2025
27 Március 2025
14 Január 2025