Használati útmutató Blackburn EX-1 Disc
Oldalak 2 Angol nincs kategorizálva
Olvassa el ingyen online a(z) Blackburn EX-1 Disc használati útmutatóját, vagy töltse le PDF-ben. Az útmutatót 21 alkalommal tekintették meg. Kérdése van a modellről? Tegyen fel kérdést

EX1 Disc™
Rack
Installation Instructions
Parts List:
6 – 10 mm Buttonhead Screws
2 – 25 mm Buttonhead Screws
8 – Nylock Nuts
2 – Extenders
2 – 1/2” Seat-Stay Clamps
2 – 9/16” Seat-Stay Clamps
1 – Reflector Bracket
1 – 3 mm Allen Wrench
Installation:
1. ATTACH EXTENDERS:
Attach extenders to
rack using four 10mm button head screws and
nylock nuts. Do not tighten. NOTE: Extenders
have an offset twist and can be installed in wide
or narrow position to match seat stay width.
2. STRUT ATTACHMENT:
Remove rear quick
release. Spread rack struts to fit on the
outside of the dropouts. Install extra long quick
release supplied with rack. Follow your
bicycle/wheel manufacturer recommendations
for removing and installing quick releases or
have a qualified bicycle shop replace it for you.
3. ATTACHING EXTENDERS:
Attach extenders
to the bike frame “Braze-on” mounts with
25mm buttonhead screws. Bend extenders (by
hand or with an adjustable wrench) to align with
braze-on mounts. NOTE: For bicycles without
seat stay “Braze-ons” use vinyl coated Seat-Stay
Clamps (2 sizes included). Attach with 10mm
screws and nylock nuts.
4. RACK ADJUSTMENT:
Adjust rack until rack
top is level with ground by sliding it on extenders
until level. Tighten all rack screws & nuts.
5. Install reflector bracket over rack and tighten
with reflector and reflector screw from your bicycle
.
Warning: Periodically check all nuts and bolts
for tightness.
Termékspecifikációk
| Márka: | Blackburn |
| Kategória: | nincs kategorizálva |
| Modell: | EX-1 Disc |
Szüksége van segítségre?
Ha segítségre van szüksége Blackburn EX-1 Disc, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek