Használati útmutató Blaupunkt THA500.1
Blaupunkt
nincs kategorizálva
THA500.1
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Blaupunkt THA500.1 (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 3.5 felhasználó értékelte átlagosan 3.6 csillagra
Oldal 1/8

THA500.1
1 062 310 500 001


Warranty
We provide manufacturer's warranty for 12 months
from the date of sale for Blaupunkt products purchased
within India.
Recommendation
The performance of an amplier can only be as good as
its installation. Correct installation increases the overall
performance of your car sound system. The THA
amplier should be installed by a trained person. If you
would like to install it yourself, please read these
installation instructions very carefully and allow yourself
sufficient time for the installation.
In conclusion, allow us a few words about the topic of
health protection:
During playback of music in your vehicle, please
consider that continuous sound-pressure levels above
100 dB can lead to permanent damage of the human ear
& in some cases loss of hearing. Using today's high-
performance systems and loudspeaker congurations
allows for reaching sound-pressure levels above 130 dB.
Safety notes
Please observe the following safety notes during the
installation and connection.
- Disconnect the negative terminal of the battery!
Observe safety notes of the vehicle manufacturer.
- When you drill holes, ensure that you do not damage
any vehicle components.
- Please use minimum 10AWG power & ground cable
with a fuse located within 18 inches of the battery.
- Use cable glands for holes with sharp edges.
- Incorrect installation can result in malfunction of
vehicle electronic systems or sound system.
Installation and connection instructions
With respect to accident safety, the THA 500.1 must be
secured fastened at its mounting location.
When selecting the installation location, select a dry
location that offers sufficient air circulation for cooling
the amplier.
The THA 500.1 must not be installed on rear shelves, rear
seats or other locations that are open to the passenger
cabin.
The installation location must be suitable to accept the
accompanying screws and provide a rm support.
The amplier power cable must be tted with a fuse no
more than 45 cms from the battery to protect the vehicle
battery in case of a short circuit between power
amplier and battery. The fuse of the amplier protects
only the amplier, not the vehicle battery.
Use loudspeakers with 2 - 4 Ohms impedance (see table
or installation drawing). Do not connect loudspeakers to
ground, use only the referenced terminals.
Audio inputs (see Fig. 3)
You can select between 2 different audio inputs;
- Cinch (RCA)
- Hi level (loudspeaker connections)
Use only one of the audio inputs; otherwise, it may lead
to audio interference.
The preamplier outputs are connected to the cinch
(RCA) sockets ) via a shielded sound cable. j
With control via the loudspeaker outputs, the input
connections of pos. / are fed to the closest k l
loudspeaker cables (front or rear) on the left and right.
They are separated and connected to the input
connections. The polarity of the +or - connections must
be observed. Bridge output stages (BTL) can also be
connected directly without an additional adapter.
Positive / negative connection
- We recommend a minimum cross section of 10 AWG
- Route commercially available positive cable to the
battery and connect via fuse holder.
- Use cable glands for holes with sharp edges.
- Securely fasten commercially available negative
cables to a noise-free ground point (chassis screw,
chassis metal) not to the negative pole of the battery.
- Scrape the contact surfaces of the ground point until
they are bright and grease with graphite grease.
Integrated fuses (Fuse)
The fuses integrated in the amplier (Fuse) protect the
power amplier and the entire electrical system in case
of an error. If a replacement fuse is used, never bridge
fuses or replace them with a type with higher current.
1 x 500 W / 2
25 Hz - 500 Hz
> 100 dB @ RMS power
> 75 dB @ 1W/1kHz
<0.15%
0.2 / 5V
50 - 500Hz
185 x 54 x 184
7.3 x 2.1 x 7.3
0 dB / 6 dB
THA500.1 THA500.1
RMS power
Termékspecifikációk
Márka: | Blaupunkt |
Kategória: | nincs kategorizálva |
Modell: | THA500.1 |
Szüksége van segítségre?
Ha segítségre van szüksége Blaupunkt THA500.1, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók nincs kategorizálva Blaupunkt
11 Január 2025
7 Január 2025
5 Január 2025
5 Január 2025
5 Január 2025
7 December 2024
7 December 2024
5 December 2024
5 December 2024
10 Október 2024
Útmutatók nincs kategorizálva
- nincs kategorizálva EXSYS
- nincs kategorizálva BT
- nincs kategorizálva Ergodyne
- nincs kategorizálva Bogen
- nincs kategorizálva Bialetti
- nincs kategorizálva Maxxmee
- nincs kategorizálva Peltor
- nincs kategorizálva Heaven Fresh
- nincs kategorizálva GPO
- nincs kategorizálva Renogy
- nincs kategorizálva Grizzly
- nincs kategorizálva Bleep Labs
- nincs kategorizálva Electro Harmonix
- nincs kategorizálva Kisag
- nincs kategorizálva Brinno
Legújabb útmutatók nincs kategorizálva
10 Április 2025
10 Április 2025
10 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025