Használati útmutató Byron DIC-23216

Byron Ajtócsengő DIC-23216

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Byron DIC-23216 (29 oldal) a Ajtócsengő kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 3.5 felhasználó értékelte átlagosan 4.3 csillagra

Oldal 1/29
DIC-23216
MANUAL
Installation
As the battery may not be fully charged out of the box, it is recommended to plug the doorbell into the
mains using the pre installed power cable and power supply during set up. The main button will light up - -
white during charging.
The power cable comes pre installed to easy up out of the box. You can keep this connected and - -set
keep the doorbell powered from use and charge the the mains or you can remove it for full wire free
doorbell -every 4 6 months depending on use. To remove the power cable unscrew the rear cover and
disconnect from the doorbell.
Alternatively, you can also charge the unit using -the Micro USB cable and connect this to the
charger port at the bottom of the doorbell when required.
Doorbell setup
1. Remove the wall fixing base by using the supplied screwdriver to loosen the security screw at
the base of the doorbell then slide the base plate down and off the doorbell.
2. Pull the charger port cover open.
3. help Pull the front cover off the doorbell by pulling the bottom first. You can use a blunt tool to
you with this. This will reveal the power and re set buttons at the bottom of the - doorbell.
4. At the bottom, press the right hand power button for 2 seconds to turn on the device. The main
button will start to flash blue and white.
5. Open the MicroSD card cover to reveal the MicroSD card slot.

Termékspecifikációk

Márka: Byron
Kategória: Ajtócsengő
Modell: DIC-23216

Szüksége van segítségre?

Ha segítségre van szüksége Byron DIC-23216, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek