Használati útmutató Chord Blu

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Chord Blu (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 23 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 5.0 csillagra

Connecting BLU MKII to DAVE 3.0

Connect BLU MKII to DAVE via dual data mode. You can use either

BNC 1 and 2 or BNC 3 and 4. Navigate forward (not backwards) to

BNC 1 if outputs from BLU MKII are connected to BNC inputs 1 and 2

on DAVE, or navigate to BNC 3 if outputs from BLU MKII are connected

to BNC inputs 3 and 4.

Chord Electronics

BLU MKII | Quickstart Manual

The Pumphouse, Farleigh Lane, East Farleigh, Kent, ME16 9NB, United Kingdom

info@chordelectronics.co.uk

chordelectronics.co.uk

Quickstart Manual

Introduction 1.0

Welcome to the Blu MK II Quickstart Guide. This shortened guide is

supplementary to the main manual which should be referred to for full

safety and operational information.

Please note, more information on any of these topics is listed within the

full manual found under the product page:

chordelectronics.co.uk/product/blu-mk-2

Warranty 1.1

The BLU MK II comes with a comprehensive 5-year warranty. To

activate this warranty, please register your device via the Chord

Electronics website:

chordelectronics.co.uk/register-product

Connecting to a source 2.0BLU MKII

In order to use your BLU MKII as an upscaler/upsampler, you must

connect your source to any input of BLU MK II. You can connect up to

2 devices. When using a MAC/Linux device with USB you will not need

a driver but a Windows device will need a driver from the BLU MKII

section of our website:

chordelectronics.co.uk/product/blu-mk-2

USB

Input

BNC

Input

Connecting BLU MKII to third-party DACs 4.0

Use the Dual BNC, single BNC or AES outputs to connect your BLU

MKII with a third-party DAC. Dual BNC will only fuction with the 2

further right hand side BNC ports. The bottom left BNC port can not

be used as a Dual BNC connector.

For single BNC connectors use any of the 3 BNC outputs shown below

in Blue. The top left hand side BNC port is only to be used for an input

into the BLU MKII.

OR

Output

Termékspecifikációk