Használati útmutató Crestron MC3

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Crestron MC3 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 12 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 5.0 csillagra

DOGUIDE

DO Install the Device

The MC3 is designed to be placed onto a at surface.

DO Make Connections

Make the necessary connections as called out in the diagrams

below. Connect power last.

When making connections to the MC3, note the following:

•Use Crestron® power supplies for Crestron equipment.

•The included cable(s) cannot be extended.

NOTE: Ensure the unit is properly grounded by connecting the

chassis ground lug to an earth ground (building steel).

NOTE: The MC3 can be powered via the Cresnet® connection

or with the (included) 24-Vdc power pack.

DO Congure the Control System

The MC3 can be congured using Crestron Toolbox™ software

and the built-in, web-based setup tool.

1. Use Crestron Toolbox to set the time zone. For details,

refer to the Crestron Toolbox help le.

2. Use the Internet Explorer® web browser to navigate to

http://xxx.xx.xx.xxx/setup, where xxx.xx.xx.xxx is the

IP address of the control system. The control system’s

welcome screen is displayed.

NOTE: The web-based setup tool is accessible only from

Internet Explorer.

NOTE: If a security warning is displayed, click Install to

continue.

DO Check the Box

QTYPRODUCTCOLORPART NUM.

1Connector, 3-PinGreen2003575

2Connector, 4-PinGreen2003576

1Antenna, 2.4 GHz, 1/4 Wave, Reverse Polarity, FemaleBlack2001016

1Power Pack, 24 Vdc, 2.5 A, 100-240 VacBlack2045873

1Power Cord, 5' 10" (1.78 m)2042043Black

1Cable, USB 2.0, A-B, 6’ (1.83 m)Black2014966

MC3

3-Series® Control System with Wireless Gateway

COM 1 - 2 Connections

PIN DESCRIPTION

2RXD - Receive Data

3TXD - Transmit Data

5SG - Signal Ground

7RTS - Request To Send

8CTS - Clear To Send

•Use with a standard DB9 straight

through cable.

•Pins 1, 4, 6, and 9 are not used but may

be connected.

AUDIO IN (L R):

From Audio Source

AUDIO OUT (L R):

To OSD Device or

Associated Amplifier

VIDEO OUT

(COMPOSITE):

To OSD Device

IR 1–5:

To IR Controlled

Devices

IR IN:

From IR

Device

VIDEO OUT (Y Pb Pr):

To OSD Device

COM 1–2:

To RS-232 Device

LAN:

10/100 Base-T

Ethernet to LAN

NET (24 Y Z G):

To Cresnet Network

RELAY 1–2:

To Controllable

Devices Ground

24 Vdc:

From Power

Supply

USB 1–2:

To USB HID Device

or USB Mass

Storage Device

INPUT:

From Control

Devices

Termékspecifikációk