Használati útmutató Danby DSL120BA

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Danby DSL120BA (3 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 3.5 felhasználó értékelte átlagosan 3.6 csillagra

Oldal 1/3
THROUGH-THE-WALL AIR CONDITIONER SLEEVE INSTALLATION INSTRUCTIONS
ACCESSORIES
1. Top panel
2. Bottom panel
3. Left side panel
4. Right side panel
5. Front cover panel
6. Rear cover panel
7. Bracket (x4)
8. Clasp (x4)
9. Screw (x28)
10. Washer (x8)
1
2
3
4
5
6
7
8
9
10
4” min
1/2” min
Assembled dimensions:
25 1/2” (64.8 cm) wide
15 1/4” (38.8 cm) tall
17 1/2” (44.4 cm) deep
The sleeve must be installed a minimum of 4”
above any fl oor or heat source such as baseboard
heaters or radiators. The sleeve must be installed a
minimum of 1/2” outside the building.
1. Use four screws to
fasten the side panels
to the bottom panel.
The arrow marks
on the bottom panel
indicate the direction
of the indoor side.
2. Attach the top panel
using four screws.
3. Insert the four clasps
into the holes in the
side panels.
Expanded rear grille Louvered rear grille
4. Insert the louvered rear grille or the expanded
rear grille that was packed with the air
conditioner.
The wall sleeve must be securely fastened to the
wall before installing the air conditioner.
After the sleeve is installed, caulk where
necessary around the entire interior and exterior
wall opening.
1

Termékspecifikációk

Márka: Danby
Kategória: nincs kategorizálva
Modell: DSL120BA

Szüksége van segítségre?

Ha segítségre van szüksége Danby DSL120BA, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek