Használati útmutató Dormakaba HSW-GP

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Dormakaba HSW-GP (9 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 25 ember találta hasznosnak és 3 felhasználó értékelte átlagosan 4.6 csillagra

DORMA-Glas800.52.069.6.32Stand/Issue 02/03Seite/Page 1/9

HSW-GP Installation instructions

Note: The as-delivered condition is indicated in the manufacturing drawing enclosed.

1. Ceiling substructure for track rail and installation of the track rail:

The track rail must be bolted over its entire length (including the stacking track area) to a correctly

aligned horizontal (longitudinally and transversely) ceiling steel substructure (e.g. DORMA substructure

system).

The steel substructure should be designed to accommodate the total weight of all the panels both in the

stacking area and in the partition section. The fixing point intervals for the track rail should be approx.

300 mm along the straight sections and approx. 100 mm in the stacking area.

Caution: All the track joints (except the maintenance end piece, Section 5, page 7) must be provided

with connection pins (a) in order to ensure a flush transition between the track sections and thus

smooth sliding panel operation. (Fig. 1)

a

Fig. 1

2. Mounting the glass panel fittings (Fig. 2A):

AMounting the single-point fixings to the glass:

Insert clamping collar (2) together with the tapered countersunk fastener (1) in the glass bore.

Place the intermediate layer (3) in the nut (4) and screw the nut onto the countersunk fastener. Using

the special wrench, pre-assemble and then tighten with a torque wrench (tightening torque = 15 Nm).

Termékspecifikációk