Használati útmutató DPW Design Mix

Olvassa el alább 📖 a magyar nyelvű használati útmutatót DPW Design Mix (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 15 ember találta hasznosnak és 3 felhasználó értékelte átlagosan 4.4 csillagra

Mix

The Mix is a compact 4 channel stereo mixer that also can be set up to be set up to be up to 8

channels of mono with crossfading in 4 groups. It also has a built in soft knee limiter for subtle level

control or harder creative coloring of the sound.

It is designed to be a flexible compact part of your system. As the main mixer for a small system or

you have a few distributed in your bigger system and use one to collect the signals from all of them

sa the main out.

The unit can be used as a utility module for control voltages as well as for audio. It is DC coupled.

Inputs, stereo mode

There are 4 channels of stereo input with volume and pan control.

When using one of the channels with mono in stereo mode you can

connect to either left or right channel. The left and right inputs are

normalled to each other.

All channels have one time amplification (unity gain) when the Vol

knob is turned fully clockwise.

The module is designed to never clip internally but the levels can get

high at the output stage. So the output stage has a controlled nice

sounding round clipping that limits the output to +/- 10V.

Use the output LEDs as a guide to get an output level that doesn't

clip.

The bandwidth of the module in this mode is 150 kHz (-3dB point) so

there is basically no unwanted frequency dependent phase shift in the

audio range.

The extended bandwidth will also make the sound of the mixer very

transparent.

M switches

The M switches (mono) turns the channels left and right input to dual

mono with the Vol knob as a volume for both and the Pan becomes a

mono crossfade between the left and right input.

The M switches affects the channels in two groups. The upper M switch affects channel 1 and 2.

the lower affects channel 3 and 4.

This means that engaging one or two M switches can give you 4 mono with two groups of

crossfade plus two stereo channels or 8 channels of mono with 4 groups of crossfade.

The crossfade can be used as a performance feature to gradually crossfade from one part of your

system to an other or to build more complex voices.

If only one side of a channel is connected, the M switch for that channel is on and Pan is in center

possition you will get a two times amplification of that channel. Can be used for extra boost where

needed.

DPW Design, Häradsvägen 200, 14171 Segeltorp, Sweden

www.dpw.seMAN-M1 Rev B

Termékspecifikációk