Használati útmutató Electro-Voice EVA-1151D

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Electro-Voice EVA-1151D (2 oldal) a hangszóró kategóriában. Ezt az útmutatót 17 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 5.0 csillagra

Oldal 1/2
EVA-AM
Attenuation Module
for EVA Loudspeakers
Installation Instructions
Tools Required:
1. Remove the input panel by removing the eight screws securing it.
2. Carefully unplug the crossover cable from the 10-pin header.
3. Unplug and discard the 7-pin jumper connector at the far end of the circuit board.
Instructions:
1. #2 Phillips Screwdriver 2. 3/16” (5mm) Flat Blade Screwdriver
3/16”
[5mm]
#2
4. With the green circuit board on the
right, place the attenuation module
in the pocket provided for it on the
left with the lead wires from the
module pointing toward you.
5. Secure the EVA-AM mounting ears
to the four input panel bosses
with the four #10 screws provided.
Carefully tighten the screws evenly
in an X-cross pattern to avoid
warping the plastic input panel.
6. Plug in the 7-pin wiring harness
connector from the attenuation
module where the 7-pin jumper
was removed in step 3.
Figure 1:
Remove panel, unplug
crossover cable and jumper
Figure 2:
Attach module and plug in
7-pin module connector
7-pin
10-pin

Termékspecifikációk

Márka: Electro-Voice
Kategória: hangszóró
Modell: EVA-1151D

Szüksége van segítségre?

Ha segítségre van szüksége Electro-Voice EVA-1151D, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek