Használati útmutató Extech MN10
Extech
multiméter
MN10
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Extech MN10 (8 oldal) a multiméter kategóriában. Ezt az útmutatót 8 ember találta hasznosnak és 4.5 felhasználó értékelte átlagosan 4.5 csillagra
Oldal 1/8
User's Guide
Pocket MultiMeter
Model MN10
MN10-en-GB_V1.3 09/16
2
Introduction
Congratulations on your purchase of the Extech MN10 Pocket Multimeter. This meter measures
AC/DC Voltage, DC Current, Resistance, Diode Test, and Battery test. It features a rugged design for
heavy duty use This meter is shipped fully tested and calibrated and, with proper use, will provide
years of reliable service.
Safety
This symbol adjacent to another symbol, terminal or operating device indicates
that the operator must refer to an explanation in the Operating Instructions to
avoid personal injury or damage to the meter.
This WARNING symbol indicates a potentially hazardous situation, which if not
avoided, could result in death or serious injury.
This CAUTION symbol indicates a potentially hazardous situation, which if not
avoided, may result damage to the product.
This symbol advises the user that the terminal(s) so marked must not be
connected to a circuit point at which the voltage with respect to earth ground
exceeds 500 VAC or VDC.
This symbol adjacent to one or more terminals identifies them as being associated
with ranges that may, in normal use, be subjected to particularly hazardous
voltages. For maximum safety, the meter and its test leads should not be handled
when these terminals are energized.
This symbol indicates that a device is protected throughout by double insulation or
reinforced insulation.
WARNING
CAUTION
MAX
500V
MN10-en-GB_V1.3 09/16
3
SAFETY INSTRUCTIONS
This meter has been designed for safe use, but must be operated with caution. The rules listed below
must be carefully followed for safe operation.
1. NEVER apply voltage or current to the meter that exceeds the specified maximum:
Input Protection Limits
Function Maximum Input
V DC or V AC 500VDC/AC
mA AC/DC 200mA AC/DC
Resistance, Diode Test 500VDC/AC
2. USE EXTREME CAUTION when working with high voltages.
3. DO NOT measure voltage if the voltage on the "COM" input jack exceeds 500V above earth
ground.
4. NEVER connect the meter leads across a voltage source while the function switch is in the
current, resistance, or diode mode. Doing so can damage the meter.
5. ALWAYS discharge filter capacitors in power supplies and disconnect the power when making
resistance or diode tests.
6. ALWAYS turn off the power and disconnect the test leads before opening the covers to replace
the fuse or batteries.
7. NEVER operate the meter unless the back cover and the battery and fuse covers are in place
and fastened securely.
8. If the equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
Controls and Jacks
1. NCV indicator lamp
2. LCD Display
3. Power button
4. Function switch
5. COM jack
6. Data Hold button
7. Battery compartment (rear)
8. Positive jack
Symbols and Annunciators
Diode test Ω Ohms
Low Battery V Volts
µ micro A Amps
m milli AC Alternating current
A Amps DC Direct current
k kilo
Termékspecifikációk
| Márka: | Extech |
| Kategória: | multiméter |
| Modell: | MN10 |
Szüksége van segítségre?
Ha segítségre van szüksége Extech MN10, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók multiméter Extech
23 December 2024
19 Szeptember 2024
30 Augusztus 2024
25 Augusztus 2024
25 Augusztus 2024
25 Augusztus 2024
20 Augusztus 2024
15 Augusztus 2024
12 Augusztus 2024
11 Augusztus 2024
Útmutatók multiméter
- multiméter Parkside
- multiméter Stanley
- multiméter Bruder Mannesmann
- multiméter Altai
- multiméter CEM
- multiméter Weltron
- multiméter Aim TTi
- multiméter Silverline
- multiméter Hager
- multiméter Profile
- multiméter Amprobe
- multiméter Högert
- multiméter Topcraft
- multiméter Wiha
- multiméter Flir
Legújabb útmutatók multiméter
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
3 Április 2025
28 Március 2025
26 Március 2025
14 Január 2025