Használati útmutató Fluke i6000s Flex

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Fluke i6000s Flex (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 17 ember találta hasznosnak és 8 felhasználó értékelte átlagosan 4.8 csillagra

i 6000s Flex

AC Current Probe

Instruction Sheet

Introduction

The i6000s 24 Flex and i6000s 36 Flex CPs (tAC urrent robehe

Probe) are used with oscilloscopes, digital multimeters, recorders

or data loggers.can be used to measure AC current PTherobes

up to 6000 A. The flexible measuring head allows current

measurements on conductors that are hard to reach or

inaccessible using typical on current probes.clamp-

The Probes provide a lowvoltage (3- V ac) output that is

proportional to the current being measured. The provideProbes

full-scale direct readings for 60 A, 600A, and 6000 A.

Safety Instructions

A Warning identifies conditions andprocedures that are

dangerous to the user. A Caution identifies conditions and

procedures that can cause damage to the Product or the

equipment under test.

 Warning

To prevent electric shock or personal injury:

•If the Probes are used in a manner not

specified in these operating instructions,

protection provided by the Probes may be

impaired.

•Use the Probes only if qualified.

•Use caution during installation and use of the

Probes; high voltages and currents may be

present in circuit under test.

•Have maintenance performed by only qualified

service personnel.

•Protect the Probes against water and

humidity.

PN 2842359

June 200 7, Rev. 26/21 ,

©200720-21 Fluke Corporation. All rights reserved.

S pecifications are subject to change without notice.

All product names are trademarks of their respective companies.

Termékspecifikációk