Használati útmutató Fluke SBP3
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Fluke SBP3 (2 oldal) a Accu kategóriában. Ezt az útmutatót 21 ember találta hasznosnak és 11 felhasználó értékelte átlagosan 4.4 csillagra
Oldal 1/2
FLK-TI-SBC3B
Charging Base/Power Supply with Adapters
Instruction Sheet
The Fluke FLK-TI-SBC3B Charging Base/Power Supply with Adapters charges the Fluke
FLK-TI-SBP3B Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3B consists of a
charging base, power supply, and power outlet adapters.
PN 4352179 May 2013
© 2013 Fluke Corporation. All rights reserved.
All product names are trademarks of their respective companies. Specications are subject to change without notice.
Safety Information
Use the FLK-TI-SBC3B only as specied in this instruction sheet or other Fluke
product-specic manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3B.
A Warning identies hazardous conditions and procedures that are dangerous to the user.
A Caution identies conditions and procedures that may cause damage to the Product or
the equipment under test.
W Warning
To avoid injury:
●Do not disassemble or short circuit the battery pack.
●Do not expose the battery pack to temperatures above 50 °C (122 °F).
●Do not incinerate or mutilate the battery pack.
●Use only ac adapters approved by Fluke for the product to charge the battery or
power the product.
Table 1. Symbols
Symbol Description
PConforms to requirements of European Union and European Free Trade Association.
"Imager connected to battery charger.
;Conforms to relevant Australian standards.
)Conforms to relevant Canadian and US standards
WImportant information. See manual.
~ This product complies with the WEEE Directive (2002/96/EC) marking requirements.
The afxed label indicates that you must not discard this electrical/electronic product in
domestic household waste. Product Category: With reference to the equipment types
in the WEEE Directive Annex I, this product is classed as category 9 “Monitoring and
Control Instrumentation” product. Do not dispose of this product as unsorted municipal
waste. Go to Fluke’s website for recycling information.
Charging the Battery
Before using the battery pack for the rst time, charge the battery in the two-bay charging
base for at least two and one-half hours. For complete charging instructions, see the
Thermal Imagers User Manual.
Specications
See Table 2 for the specications.
Table 2. Specications
Battery Charging 10-15 Vdc 2 A or charge battery pack in Imager with included ac
adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
Charging / Power LED
Status Charging LED Power LED
off no battery detected no dc power input
solid green charged dc power present
blinking green charging na
blinking red fault na
Dimensions 159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
Operating Temperature -10 °C to 70 °C (-14 °F to 158 °F)
Storage Temperature -20 °C to 80 °C (-4 °F to 176 °F) without batteries
Humidity Range 10 % to 95 % non-condensing
Termékspecifikációk
| Márka: | Fluke |
| Kategória: | Accu |
| Modell: | SBP3 |
Szüksége van segítségre?
Ha segítségre van szüksége Fluke SBP3, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók Accu Fluke
8 Október 2024
4 Augusztus 2024
27 Július 2024
26 Július 2024
24 Július 2024
23 Július 2024
22 Július 2024
Útmutatók Accu
- Accu Deltaco
- Accu Nedis
- Accu Ozito
- Accu Bolt
- Accu Aluratek
- Accu EGO
- Accu RYOBI
- Accu Abus
- Accu Belkin
- Accu SKROSS
- Accu Arris
- Accu LSI
- Accu Trust
- Accu Inovonics
- Accu PNY
Legújabb útmutatók Accu
3 Április 2025
10 Január 2025
4 Január 2025
3 Január 2025
1 Január 2025
31 December 2025
31 December 2025
31 December 2025
30 December 2025
30 December 2025