Használati útmutató Garmin GSC10

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Garmin GSC10 (2 oldal) a Pulzusmérő kategóriában. Ezt az útmutatót 30 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.8 csillagra

➍

Adjust and Test

1. Unscrew and move the sensor arm to within 5 mm of the

spoke magnet. You can also tilt the GSC10 closer to either

magnet for improved alignment.

2. Press the button on the GSC10. The LED light turns Reset

red, then green. Pedal to test the sensor alignment. The red

LED blinks each time the crank arm passes the sensor, and

the green LED blinks each time the wheel magnet passes

the sensor arm.

Note: The LED blinks for the first 60 passes after a reset.

Press again if you require additional passes. Reset

3. When everything is aligned and working correctly, tighten

the cable ties, sensor arm, and spoke magnet.

➊

Install the GSC10 Sensor

Place the GSC10 on the rear chain stay (the side opposite

of the drive train). Loosely attach the GSC10 using two

cable ties.

reset button

cable ties

indication

line

GSC10 on rear chain stay

For more information on using the GSC10 with your compatible

GPS device, refer to your owner’s manual.

➋

Install the Pedal Magnet

Attach the pedal magnet to the crank arm using the

adhesive mount and a cable tie. Make sure the pedal

magnet is within 5 mm of the GSC10, and the indication line

on the pedal magnet is aligned with the indication line on the

GSC10.

cable tie

indication

line

Pedal magnet on crank arm

➌

Install the Spoke Magnet

Attach the spoke magnet by unscrewing the magnet from

the plastic piece. Then place the spoke in the groove of the

plastic piece and tighten slightly. The magnet can face away

from GSC10 if there is not enough room between the sensor

arm and spoke. Make sure the magnet is aligned with the

sensor arm indication line.

pedal magnet sensor arm

indication line

spoke magnet

GSC10

Termékspecifikációk