Használati útmutató Garmin nuvi 250

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Garmin nuvi 250 (28 oldal) a Személyes navigáció kategóriában. Ezt az útmutatót 7 ember találta hasznosnak és 4 felhasználó értékelte átlagosan 4.6 csillagra

Oldal 1/28
vi® 200-Series Bicycle Mount
Instructions 2–3 ………………………
Instructions (Français) 4–5 ………….
Istruzioni 6–7 ………………………
Anweisungen 8–9 ……………………
Instrucciones 10–11 ………………….
Instruções 12–13 ……………………..
Instructies 14–15 ……………………..
Instruktioner 16–17 …………………..
Ohjeet 18–19 ………………………
Instruksjoner 20–21 ………………….
Instruktioner 22–23 …………………..
Инструкции………… ……… 24–25
2-EN
InstructIons
The nüvi
®
200-series bicycle mount allows
you to attach your nüvi to your bicycle.
Garmin
®
s standard Limited Warranty
applies to this accessory. Refer to the limited
warranty and safety warnings in your nüvi Set
Up and Go guide before installing the bicycle
mount.
Do not expose the nüvi to caution:
water. Contact with water can cause the
nüvi to malfunction.
warning: You are responsible for
obeying all trafc laws when using your
nüvi on your bicycle, scooter, or other
vehicle with handlebars.
You can install the bicycle mount to the stem
or handlebars. The stem installation (shown
here) provides a more sturdy location. The
optional wedge should be used under the
mount for a better viewing angle.
To attach the bicycle mount to your
bicycle stem:
1. Insert the hard plastic half of the bicycle
mount into the half with the rubber
backing.
Release lever
Bike mount
Wedge (optional)
EN-3
For horizontal bars: Separate and
remove the top part of the mount, turn it
90 degrees, and replace. Continue with
step 2.
2. Place the wedge on the bicycle stem,
and then place the bicycle mount on
the wedge. Make sure the release lever
is on the left.
3. Thread the two cable ties through the
two slots on the bicycle mount. Position
the mount on your bicycle and attach
using the cable ties.
Release
lever
Cable ties
To attach the cradle to the bicycle
mount:
1. Fit the bottom of the nüvi in the cradle,
and snap the top of the nüvi into place.
2. Align the cradle with the bicycle mount.
3. Slide the cradle left onto the bicycle
mount until it snaps into place.
Change the Usage Mode on your TIP:
nüvi. Touch > > > Settings System
Usage Mode Bicycle > .
To release the cradle:
1. Remove the nüvi from the cradle.
2. Press down on the release lever, and
slide the cradle to the right.

Termékspecifikációk

Márka: Garmin
Kategória: Személyes navigáció
Modell: nuvi 250

Szüksége van segítségre?

Ha segítségre van szüksége Garmin nuvi 250, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Személyes navigáció Garmin

Útmutatók Személyes navigáció

Legújabb útmutatók Személyes navigáció