Használati útmutató Garmin Nüvi 260

Garmin Navigator Nüvi 260

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Garmin Nüvi 260 (28 oldal) a Navigator kategóriában. Ezt az útmutatót 3 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/28
vi® 200-Series Bicycle Mount
Instructions 2–3 ………………………
Instructions (Français) 4–5 ………….
Istruzioni 6–7 ………………………
Anweisungen 8–9 ……………………
Instrucciones 10–11 ………………….
Instruções 12–13 ……………………..
Instructies 14–15 ……………………..
Instruktioner 16–17 …………………..
Ohjeet 18–19 ………………………
Instruksjoner 20–21 ………………….
Instruktioner 22–23 …………………..
Инструкции………… ……… 24–25
2-EN
InstructIons
The nüvi
®
200-series bicycle mount allows
you to attach your nüvi to your bicycle.
Garmin
®
s standard Limited Warranty
applies to this accessory. Refer to the limited
warranty and safety warnings in your nüvi Set
Up and Go guide before installing the bicycle
mount.
Do not expose the nüvi to caution:
water. Contact with water can cause the
nüvi to malfunction.
warning: You are responsible for
obeying all trafc laws when using your
nüvi on your bicycle, scooter, or other
vehicle with handlebars.
You can install the bicycle mount to the stem
or handlebars. The stem installation (shown
here) provides a more sturdy location. The
optional wedge should be used under the
mount for a better viewing angle.
To attach the bicycle mount to your
bicycle stem:
1. Insert the hard plastic half of the bicycle
mount into the half with the rubber
backing.
Release lever
Bike mount
Wedge (optional)
EN-3
For horizontal bars: Separate and
remove the top part of the mount, turn it
90 degrees, and replace. Continue with
step 2.
2. Place the wedge on the bicycle stem,
and then place the bicycle mount on
the wedge. Make sure the release lever
is on the left.
3. Thread the two cable ties through the
two slots on the bicycle mount. Position
the mount on your bicycle and attach
using the cable ties.
Release
lever
Cable ties
To attach the cradle to the bicycle
mount:
1. Fit the bottom of the nüvi in the cradle,
and snap the top of the nüvi into place.
2. Align the cradle with the bicycle mount.
3. Slide the cradle left onto the bicycle
mount until it snaps into place.
Change the Usage Mode on your TIP:
nüvi. Touch > > > Settings System
Usage Mode Bicycle > .
To release the cradle:
1. Remove the nüvi from the cradle.
2. Press down on the release lever, and
slide the cradle to the right.

Termékspecifikációk

Márka: Garmin
Kategória: Navigator
Modell: Nüvi 260

Szüksége van segítségre?

Ha segítségre van szüksége Garmin Nüvi 260, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók Navigator Garmin

Útmutatók Navigator

Legújabb útmutatók Navigator

Alpine

Alpine CVA-1005R Útmutató

31 Március 2025
Humminbird

Humminbird 797c2 Útmutató

12 Január 2025
Navman

Navman S60 Útmutató

1 Január 2025
TomTom

TomTom Eclipse Útmutató

30 December 2025
GolfBuddy

GolfBuddy PT4 Útmutató

22 December 2024
Navman

Navman TM 550 Útmutató

14 December 2024
Navman

Navman SmartST V3 Útmutató

14 December 2024
Navman

Navman T1 Útmutató

14 December 2024