Használati útmutató GE JX1095STSS
GE
nincs kategorizálva
JX1095STSS
Olvassa el alább 📖 a magyar nyelvű használati útmutatót GE JX1095STSS (12 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 2 ember találta hasznosnak és 1.5 felhasználó értékelte átlagosan 4.7 csillagra
Oldal 1/12
PARTS INCLUDED
Part Image Part Name Quantity
Trim 1
Duct Bottom 1
Duct Upper 1
Phillips Pan
Head Sheet
Metal Screws
8
Phillips Flat
Head Wood
Screws
8
Questions? Call GE Answer Center at Visit our Website at:800.626.2000 or ppliances.comGEA
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Installation Built-In Trim Kits
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for
local inspector’s use.
• IMPORTANT – Observe all governing codes
and ordinances.
• Note to Installer – Be sure to leave these instructions with
the Consumer.
• Note to Consumer – Keep these instructions for future
reference.
• For easier installation and personal safety, we recommend
that two people install this microwave oven.
• Unplug the microwave oven before attempting installation of
this kit.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 30 minutes – 1 hour
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty.
TOOLS YOU WILL NEED
#2 Phillips
screwdriver
Pencil
Tape measure
Drill with 7⁄64” bit or #35
FOR YOUR SAFETY
WARNING Before beginning the installation, switch
power off at service panel and lock the service disconnecting
means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to
the service panel.
WARNING This oven must be plugged into a properly
grounded 3-hole, 120 volt receptacle as required by the
National Electric Code.
MODELS
JX1095STBB, JX1095STSS
31-7000180 Rev. 1 06-22 GEA
31-7000180 Rev. 1
2
CUTOUT DIMENSIONS
Minimum Maximum
Height
Width
Depth N/A
* Min. depth with receptacle outside cabinet 1912”
Min. depth with receptacle inside cabinet 22”
Installation Instructions
CAUTION
This trim kit uses air flow from the top and bottom of
the trim frame. Blocking the air flow can cause the
microwave to function improperly and may cause
damage to the microwave.
Allow a 1 clearance beyond the edge of the Trim ”
Frame to provide proper air flow.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the
electric current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.Consult a qualified electrician
or serviceman if the grounding instructions are not
completely understood, or if doubt exists as to whether
the appliance is properly grounded.
Improper use of the
grounding plug can result
in a risk of electric shock.
Do not use an extension
cord. If the power supply
cord is too short, have
a qualified electrician
or serviceman install an
outlet near the appliance.
Permanent and Correct
Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
WARNING
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 12 amps and
1.35 kilowatts. This product must be connected to a
supply circuit of the proper voltage and frequency. Wire
size must conform to the requirements of the National
Electrical Code or the prevailing local code for this
kilowatt rating. The power supply cord and plug should
be brought to a separate 15 to 20 ampere branch
circuit single grounded outlet. The outlet box should
be located in the cabinet above the oven. The outlet
box and supply circuit should be installed by a qualified
electrician and conform to the National Electrical Code
or the prevailing local code.
Depth
Width
Height
31-7000180 Rev. 1
3
Installation Instructions
2
LOCATE AND INSTALL THE
DUCT BOTTOM
Place the Duct Bottom as shown in the cabinet. The
front edge of the Duct Bottom should match with the
front edge of the Cabinet and the center notch is
directly aligned with the center line created in Step 1.
Using the Duct Bottom as a template, drill pilot holes
at the 4 screw holes. Mount the Duct Bottom using 4
of the supplied Wood Screws.
3 REVIEW THE TRIM
Take Trim and check it. The top is recogized as the
wider side with 24 vent holes and the bottom has 6
vent holes.
4 MOUNT THE TRIM
Mount the Trim to the Microwave as shown. Use 4 of
the supplied Sheet Metal Screws to fasten the Trim at
points indicated. After mounted avoid using the trim to
support the weight of the microwave.
1
MARK CENTER LINE FOR
DUCT BOTTOM
Locate the center line of the front of the cabinet
microwave cutout and draw a corresponding center
line on the bottom deck of the cabinet.
Align Notch
and Center
Line Mark
Duct Bottom
and Cabinet
aligned as
shown
Top
Termékspecifikációk
| Márka: | GE |
| Kategória: | nincs kategorizálva |
| Modell: | JX1095STSS |
Szüksége van segítségre?
Ha segítségre van szüksége GE JX1095STSS, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók nincs kategorizálva GE
13 Október 2024
6 Október 2024
18 Szeptember 2024
16 Szeptember 2024
26 Augusztus 2024
26 Augusztus 2024
17 Augusztus 2024
11 Augusztus 2024
10 Augusztus 2024
7 Augusztus 2024
Útmutatók nincs kategorizálva
- nincs kategorizálva SLV
- nincs kategorizálva Sortimo
- nincs kategorizálva Microsoft
- nincs kategorizálva Field Optics
- nincs kategorizálva Dracast
- nincs kategorizálva Morningstar
- nincs kategorizálva Primewire
- nincs kategorizálva Aston Microphones
- nincs kategorizálva Consul
- nincs kategorizálva Now TV
- nincs kategorizálva Sunny
- nincs kategorizálva Glide Gear
- nincs kategorizálva Gaffgun
- nincs kategorizálva Sparkle
- nincs kategorizálva ETiger
Legújabb útmutatók nincs kategorizálva
10 Április 2025
10 Április 2025
10 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025
9 Április 2025