Használati útmutató Gigabyte GA-7N400V Pro2

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Gigabyte GA-7N400V Pro2 (112 oldal) a alaplap kategóriában. Ezt az útmutatót 18 ember találta hasznosnak.

/ 112 PDF

When you installing AGP card, please make sure the following notice

is fully understood and practiced. If your AGP card has "AGP 4X/8X

(1.5V) notch"(show below), please make sure your AGP card is AGP

4X/8X.

Caution: AGP 2X card is not supported by nVIDIA® nForce™ 2 IGP. You

might experience system unable to boot up normally. Please

insert an AGP Pro 4X/8X card.

Example 1: Diamond Vipper V770 golden finger is compatible with 2X/4X

mode AGP slot. It can be switched between AGP 2X(3.3V) or 4X(1.5V) mode

by adjusting the jumper. The factory default for this card is 2X(3.3V). The

GA-7N400V Pro2 / GA-7N400V / GA-7N400V-L (or any AGP 4X/8X only)

motherboards might not function properly, if you install this card without

switching the jumper to 4X(1.5V) mode in it.

Example 2: Some ATi Rage 128 Pro graphics cards made by "Power Color",

the graphics card manufacturer & some SiS 305 cards, their golden finger is

compatible with 2X(3.3V) / 4X(1.5V) mode AGP slot, but they support

2X(3.3V) only. The GA-7N400V Pro2 / GA-7N400V / GA-7N400V-L (or any

AGP 4X/8X only) motherboards might not function properly, If you install this

card in it.

Note : Although Gigabyte's AG32S(G) graphics card is based on ATi Rage

128 Pro chip, the design of AG32S(G) is compliance with AGP 4X(1.5V)

specification. Therefore, AG32S(G) will work fine with nVIDIA® nForce2 IGP

based motherboards.

Before you install PCI cards, please remove the Dual BIOS label from PCI

slots if there is one.

AGP 4X/8X notch

7n400vPro2_1001_f.p65 2003/9/18, ¤U¤È 04:071

Termékspecifikációk