Használati útmutató Gigabyte GA-8IG1000-G

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Gigabyte GA-8IG1000-G (104 oldal) a alaplap kategóriában. Ezt az útmutatót 10 ember találta hasznosnak.

/ 104 PDF

When you installing AGP card, please make sure the following notice

is fully understood and practiced. If your AGP card has "AGP 4X/8X

(1.5V) notch"(show below), please make sure your AGP card is AGP

4X/8X (1.5V).

Caution: AGP 2X card is not supported by Intel® 845(GE/PE) / 845(E/G)

/ 850(E) / E7205 / 865(G/PE/P) / 875P. You might experience system

unable to boot up normally. Please insert an AGP 4X/8X card.

Example 1: Diamond Vipper V770 golden finger is compatible with 2X/4X

mode AGP slot. It can be switched between AGP 2X(3.3V) or 4X(1.5V) mode

by adjusting the jumper. The factory default for this card is 2X(3.3V). The

GA-8IG1000 Series (or any AGP 4X/8X only) motherboards might not

function properly, if you install this card without switching the jumper to 4X

(1.5V) mode in it.

Example 2: Some ATi Rage 128 Pro graphics cards made by "Power Color",

the graphics card manufacturer & some SiS 305 cards, their golden finger is

compatible with 2X(3.3V)/4X(1.5V) mode AGP slot, but they support 2X

(3.3V) only. The GA-8IG1000 Series (or any AGP 4X/8X only) motherboards

might not function properly, If you install this card in it.

Note : Although Gigabyte's AG32S(G) graphics card is based on ATi Rage

128 Pro chip, the design of AG32S(G) is compliance with AGP 4X(1.5V)

specification. Therefore, AG32S(G) will work fine with Intel® 845(GE/PE) /

845(E/G) / 850(E) / E7205 / 865(G/PE/P) / 875Pbased motherboards.

Before you install PCI cards, please remove the Dual BIOS label from PCI

slots if there is one.

AGP 4X/8X notch

Termékspecifikációk