Használati útmutató Heatit Z-Dim2

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Heatit Z-Dim2 (5 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 31 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.4 csillagra

1. INTRODUCTION

Heatit Z-Dim2 is a Z-Wave™ rotary dimmer for many dierent types

of light xtures. The Heatit Z-Dim2 works on most low loads without

causing ickering.

The dimmer is equipped with an external switch option. This allows

you to dim and turn on/o the load from an external switch.

Heatit Z-Dim2 is very well suited for LED, and ts into System 55 frames.

When connecting low loads it is recommended to use a bypass.

NB! DIMMING

Dimming may be challenging, and we recommend checking the

compatibility of dierent light sources before installation. We are

happy to answer any questions.

2. STATEMENT REGARDING PRODUCTS FROM MULTIPLE

MANUFACTURERS

Please read this before installation

This device may be used with all devices certied with the Z-Wave

Plus™ certicate and should be compatible with such devices

produced by any manufacturer. Every primary controller is dierent

depending on the manufacturer, their target audience and intended

use/application. Please review the functionalities implemented

by the primary controller you intend to use with our Z-Wave Plus

certied device to ensure that it provides the necessary controls to

take full advantage of our product’s capabilities.

3. BEHAVIOUR WITHIN THE Z-WAVE™ NETWORK

This device may be operated within any Z-Wave network with

Z-Wave-certied devices from other manufacturers. All non-battery-

operated nodes within the network will act as repeaters regardless of

manufacturer to increase the reliability of the network. On delivery,

the device does not belong to any Z-Wave network. The device needs

to be added to an existing network to communicate with the other

devices within it. Devices may also be removed from a network. The

add/remove processes are initiated by the primary controller of the

Z-Wave network.

4. QUICK START

1. Switch o the mains voltage (turn o the fuse).

2. Open the junction box.

3. Connect according to the wiring diagram as shown in chapter 7

“Installation & wiring”.

4. After verifying the connections, switch on the mains voltage.

5. Set the primary controller in add mode (security/non-security).

6. Press the reset button on dimmer 3 times in a rapid sequence.

Heatit Z-Dim2 is now included in your Z-Wave network.

HEATIT

Z-DIM2 250W Ver 2022-A

Firmware 1.20

01.05.2022

Installers manual

TABLE OF CONTENTS

1. Introduction

2. Statement regarding products from multiple manufacturers

3. Behaviour within the Z-Wave™ network

4. Quick Start

5. Control

6. Illustrations

7. Installation and wiring

8. External Switch

9. Add/Remove

9.1 Method 1: Standard (Manual)

9.2 Method 2: SmartStart (Automatic)

10.Factory Reset

11.Startup

12.LED blinking patterns description

13.QR-Code Placement (DSK)

14.Security

15.Node Information Frame

16.Associations

16.1Setting and Removing Associations

17.Association Groups

18.Conguration Parameters

19.Autocalibration of maximum dim level

20.Command Classes

20.1Basic Command Class

20.2Multilevel Switch Command Class

20.3Meter Command Class

20.4Indicator Command Class

20.5Central Scene Command Class

21.Supported Command Classes

Product info

White RAL 9003

plastic kit

White RAL 9010

plastic kit

Dimmer unit

Art.no. 14 444 40

Termékspecifikációk