Használati útmutató Hestan Aspire 20

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hestan Aspire 20 (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 24 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 4.2 csillagra

©2017 Hestan Commercial Corporation

1

OUTDOOR CABINETS

Installation Instructions

AETRC / AETC

CABINET INSTALLATION (AETRC)

IMPORTANT - READ ALL INSTRUCTIONS BEFORE YOU BEGIN

INSTALLER SHOULD LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER

1. Your new Aspire cabinets come with doors and drawers pre-installed in their frames. It will be necessary

to detach them before installing the frame in your island structure. To remove the drawer(s) from the

frame, press the release lever (see below) on each side of the drawer to disengage the slide (up on the left,

down on the right), then pull the drawer all the way out.

Some parts have sharp edges. Care must be taken when handling the various components to avoid personal

injury. Wear gloves when handling.

TOOLS REQUIRED:

Work gloves

Safety glasses

Electric drill with assorted bits for mounting hardware, masonry anchors, etc. where needed

Phillips screwdriver

Flat-blade screwdriver

Level

Tape measure

Inspect the product to verify that there is no shipping damage. If any damage is detected, call the shipper and

initiate a damage claim. Hestan Commercial Corp. is not responsible for shipping damage. DO NOT discard

any packing material (box, pallet, straps) until the unit has been inspected.

Remove all exterior packaging materials, banding, tape, etc. Remove all protective film from the inside of your

cabinets. You may leave any exterior protective film on until after installation is complete.

RELEASE

LEVER

FRAME

Termékspecifikációk