Használati útmutató HGST UltraStar 7K4000

Olvassa el alább 📖 a magyar nyelvű használati útmutatót HGST UltraStar 7K4000 (3 oldal) a Koelkast kategóriában. Ezt az útmutatót 22 ember találta hasznosnak és 11.5 felhasználó értékelte átlagosan 4.7 csillagra

Page 1 version 1.0

Quick Installation Guide

HGST Ultrastar7K4000

Models: HUS724040ALE640

HUS724030ALE640

HUS724020ALE640

NOTE: The Deskstar 7K4000 & 5K4000hard drives

featureAdvanced Format technology. Advanced Format

increases the physical sector size on hard drives from

512 bytes to 4096 (4K) bytes, which increases drive

capacities andimproves error correction capabilities.

Please consult the

HGSTAdvanced Format Drivespage

on our websitefor more information on using these hard drives.

System Requirements for Serial ATA

The following are needed to install a Serial ATA

(SATA) drive to a system:

•SATA capable motherboard or controller card

•SATA hard drive

•SATA cable (1 meter or less in length)

Handling precautions

Set the drive down gently to prevent damage

from impact or vibration.

Do not open the ESD bag containing the drive

until needed.

Handle the drive carefully by the edges. Do not

touch the exposed printed circuit board or any

electronic components.

Do not press on the top or bottom of the drive.

Before handling the drive, discharge any static

electricity from yourself and your clothing. With

one hand, touch an unpainted metal surfaceon

your computer chassis, then touch the ESD bag

with the other hand. Remain in contact with the

chassis and the bag for a minimum of two

seconds.

Quick installation procedure

Note: Back up all data before installing drive.

1.Turn off the computer.

2.Unplug the computer.

3.Remove the computer cover as instructed by

the computer system manual.

4.Discharge static electricity (see Handling

precautions).

5.Note the mounting position of existing drives

and cables. If you are replacing a drive or any

cable, remove it now.

6.Remove the drive from the ESD bag.

7.Record the model, the part number, and the

serialnumber of the drive for future reference.

8.Attach the Serial ATA cable to the drive. Match

key on cable to connector on drive

Mounting instructions

Note: The mounting hole and connector locations are

shown in figures 1 and 2.

1.Mount the drive securely.

2.Verify all attachments.

3.Replace the computer cover.

4.Plug in the computer.

5.Turn on the computer.

6.Verify that the hard disk is recognized by the

BIOS. Instructions for accessing your BIOS

can be found in the computer system manual

or in the motherboard manufacturer

documentation. If the drive is not recognized in

the BIOS, check the following:

Termékspecifikációk