Használati útmutató Holman EzySpray 5L

Holman nincs kategorizálva EzySpray 5L

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Holman EzySpray 5L (4 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 14 ember találta hasznosnak és 7.5 felhasználó értékelte átlagosan 3.7 csillagra

Letöltés PDF

Oldal 1/4



Do not attempt to unscrew

the PRESSURETANK lid–

doing so will break the

pressurised seal and

void your warranty!

COMPONENTS

A. SPRAY HEAD

B. WAND

C. TRIGGER

D. HOSE

E. EzySpray® PRESSURETANK

F. WAND THREAD

G. LOCKING NUT

H. TANK OUTLET

I. PRESSURE GAUGE

J. SCHRADER VALVE

K. 12mm HOSE CONNECTION

L. PRESSURE RELEASE VALVE

M. GRAB HANDLE

N. PLUNGER

O. TANK OPENING

P. INLET VALVE CONNECTOR

INTRODUCTION

The portable and lightweight

HOLMAN EzySpray® is an essential tool

for your garden maintenance. The patented

pre-pressurised air tank requires no

manual pumping–connect your garden

hose, ﬁll the reservoir, and away you go!

A standard garden spray would require

manual pumping roughly 1,250 times

for 50L of spraying; the EzySpray

doesn’t need a single pump.

To ﬁll your EzySpray®, simply connect

a garden hose to the tank. The gauge

indicates how full the tank is, and the spray

wand gives all the control you need.

Adding fertiliser, herbicide or other additives to

your EzySpray® is easy. Unhook the handle, and

pour in concentrate before ﬁlling with water.

For more info and support, visit

www.holmanindustries.com.au

SPRAY HOSE CONNECTION

a. Remove the protective end cap from the ( )TANKOUTLET H

b. Screw one end of the ( ) onto the HOSE D TANKOUTLET H ( )

c. Screw the other end of the onto the threaded HOSE

end of the SPRAYWAND assembly

LFor the easiest assembly, be sure to screw the hose onto

the tank outlet screwing onto the spray wandbefore

SPRAY WAND ASSEMBLY

a. Screw the SPRAY HEAD( ) onto the A WAND THREAD ( )F

b. Loosen (do not remove) the ( ) on the ( )LOCKING NUT G TRIGGER C

c. Insert the opposite end of the ( ) through WAND B

the locking nut on the TRIGGER

d. Tighten the locking nut on the TRIGGER

e. This completes the assembly of the SPRAY WAND

Need help? Visit www.holmanindustries.com.au/5l-ezyspray/ for more product information or support.holmanindustries.com.au/ for additional help Scan me with your phone for more resources!



Your EzySpray® is not suitable

for drinking under any

circumstance

TANK PRESSURE CHECK

Before ﬁlling your EzySpray®, be sure to check the pressure gauge