Használati útmutató Hoselink 3552

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hoselink 3552 (2 oldal) a kerti tömlő kategóriában. Ezt az útmutatót 16 ember találta hasznosnak és 8.5 felhasználó értékelte átlagosan 4.9 csillagra

Oldal 1/2
1. Posion the reel where it is to be
installed and mark the rst hole
posion.
2. Drill the hole with the 10mm drill
bit, 50mm deep. ( Depth is Tip:
important, use scky tape around
the drill bit to mark 50mm depth)
3. Hammer plug into the rst hole.
4. Posion the reel again to mark the
2nd hole posion, then drill hole
as above and hammer in plug.
5. Repeat process 1-3 to drill the remaining 2 holes.
6. Set unit in place and secure with lag screws provided into
each anchor. Reference Figure 3.
For more informaon visit www.hoselink.com.au 1300 900 617 or call
Kit contents
1 1x Leader Hose
2 1x Hardware Pack
3 1x Crank Handle
4 1x Intel Tube with Seals
4x Anchors
Before you begin
Assembly instructions
Tools Required:
Phillips Screwdriver
Step 1: Attaching the Crank Handle
Locate and place the handle
over axle. Reference Figure 1.
Secure in place using
screw provided.
This product has been packaged to assure it arrives in the
best possible condion. Please be careful when unpacking.
Read instrucons prior to assembly. This kit contains parts
that can be damaged if incorrectly assembled. Please follow
instrucons carefully.
Note: Do not completely ghten bolts unl assembly is
completed. For easier assembly, we recommend that two
people assemble this product.
Please consider carefully the appropriate method
to be used in mounng this hose reel. Hardware
is included for your convenience but may not
be suitable for all mounng condions. Some
surfaces like vinyl siding or render may require
special consideraons or addional hardware.
Improper mounng can cause personal injury or
property damage. If you are unsure, contact a
home improvement professional.
CAUTION
Installation
Mounting to Concrete or Brick Masonry Construction
Tools Required:
Phillips Screwdriver
Hammer Drill or rotary drill with 10mm masonry drill bit
Small hammer or mallet
Please follow these steps carefully for installaon.
Tools Required:
13mm socket or spanner
Hammer Drill or rotary drill with 10mm masonry drill bit
Small Hammer or Mallet
Powdered Hand Drill with 1/4” (6mm) Standard Drill Bit
Phillips Screwdriver
Step 2: Attaching the Leader Hose
Remove 2 meter leader hose
from the packaging.
Leader hose can be connected to the
water inlet. Reference Figure 2.
Figure 1
Figure 2
Figure 3
Installaon guide
Decorative Wall Mount Hose Reel Manual
Items: 3552 & 3553

Termékspecifikációk

Márka: Hoselink
Kategória: kerti tömlő
Modell: 3552

Szüksége van segítségre?

Ha segítségre van szüksége Hoselink 3552, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek