Használati útmutató Hotpoint NWXR473GVAA

Hotpoint Szárítógép NWXR473GVAA

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Hotpoint NWXR473GVAA (3 oldal) a Szárítógép kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF
Oldal 1/3
NWXR473GVAA—Hotpoint 6.0 Cu. Ft. Extra-Large Capacity Gas Dryer
Specication Revised 8/99
Dryer Dimensions (in inches)
36 42
27
23-1/2
2-1/2
25-1/2
Side View Rear View
8-1/2
28-1/4
23-1/2
11-1/2
Exhaust Options:
3-way via rear, left and bottom. Dryer is shipped exhausted to the rear.
Alternate exhausting knockouts are supplied.
Circuit Requirements:
An individual properly-grounded branch circuit, with a three-prong grounding-
type receptacle, protected by a 15- or 20-amp circuit breaker or a time-delay
fuse is required.
Gas Dryer Electric Rating:
120V, 60Hz, 15 Amp
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas.
LP gas supply requires a conversion kit. Check installation instructions for
correct kit and have a qualified gas technician install a conversion kit. See
dryer ducting information for proper installation.
Installation Information: For complete information, see installation
instructions packed with product for current dimensional data.
R
Listed by
Underwriters
Laboratories
NWXR473GVAA—Hotpoint 6.0 Cu. Ft. Extra-Large Capacity Gas Dryer
Specication Revised 8/99
R
Listed by
Underwriters
Laboratories
Dryer Exhausting Information—Use Metal Duct Only
For complete information, see installation instructions packed with your dryer.
Important Note:
GE Kit Number WE14X70 needed when converting rear exhaust to bottom or side. (On large capacity models.)
Ducting Materials:
For best performance, this dryer should be vented with 4” diameter all rigid metal exhaust duct. If “all rigid metal” duct cannot be
used, then “flexible all metal” venting can be used, but it will reduce the maximum recommended duct length.
Exhaust Length Calculation:
1. Determine the number of 90° turns needed for your installation. If you exhaust to the side or bottom of dryer, add one turn.
2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is shown in the table. The maximum length
for flexible ducts are less than for rigid duct.
A turn of 45° or less may be ignored. Two 45° turns within the duct length should be treated as a 90° elbow. A turn over 45°
should be treated as a 90° elbow.
Exhausting the dryer to the outside is strongly recommended to prevent large amounts of moisture and lint from being
blown into the room. Gas dryers or any dryer located in a closet be exhausted to the outside.must
Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house floor (crawl space), or into an
attic, since the accumulated lint could create a fire hazard or moisture could cause damage. Never terminate the exhaust into a
common duct or plenum with a kitchen exhaust, since the combination of lint and grease could create a fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc. The wall cap must also be
located at least 12” above the ground or any other obstruction with the opening pointed Down.
Other terminations, such as louvered wall boxes, are acceptable provided they are equivalent to a 4” opening dampered wall cap.
Special Installation Requirements
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0” either side
3” front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52”.
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 sq. in. of open area equally distributed.
If this closet contains both a washer and a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.
• The closet should be vented to the outdoors to prevent gas pocketing in case of a gas leak in the supply line.
• No other fuel-burning appliance shall be installed in the same closet with the dryer.
Bathroom or Bedroom Installation:
• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.
Minimum Clearances other than Alcove or Closet Installation:
•Minimum clearances to combustible surfaces
0” both sides
3” rear
0 90 ft. 60 ft. 55 ft. 45 ft.
1 60 ft. 45 ft. 40 ft. 30 ft.
Super & Extra-Large 2 45 ft. 35 ft. 30 ft. 20 ft.
Capacity Models 3 35 ft. 25 ft. 20 ft. 15 ft.
All Electric Dryers 4 25 ft. 15 ft. 15 ft. 10 ft.
0 45 ft. 30 ft. 30 ft. 15 ft.
Super & Extra-Large 1 35 ft. 20 ft. 20 ft. 10 ft.
Capacity Models 2 25 ft. 10 ft. 10 ft. —
All Gas Dryers 3 15 ft. — — —
0 60 ft. 48 ft. 30 ft. 18 ft.
1 52 ft. 40 ft. 22 ft. 14 ft.
Large Capacity 2 44 ft. 32 ft. 14 ft. 10 ft.
Electric and 3 32 ft. 24 ft. — — ft.
Gas Dryers 4 28 ft. 16 ft. — — ft.
Number
of
90°
Turns
Maximum Length of 4"
Dia. DuctRigid Metal
Maximum Length of 4"
Dia. DuctFlexible Metal
Exhaust Hood Type Exhaust Hood Type
Domestic
Dryer Models
Cat. No.
WX8X59
(Preferred)
A
4" Opening
B
2-1/2"
Opening
Cat. No.
WX8X59
(Preferred)
A
4" Opening
B
2-1/2"
Opening
4
Best Performance
B
2-1/2
A
Specication Revised 8/99
NWXR473GVAA—Hotpoint 6.0 Cu. Ft. Extra-Large Capacity Gas Dryer
Features and Benefits
• Extra-Large Capacity (6.0 Cubic Feet)
• Automatic Dry Control
• 7 Cycle Selections: Cottons with Optional Press Guard, Permanent Press with Optional
Press Guard, 80 Minute Timed Dry, Damp Dry, De-Wrinkle
• 4 Heat Selections
• Variable End-of-Cycle Signal
• Up-Front Lint Filter
• Dryer Interior Light
• Double-Coated Drum
• Front Serviceable
• Reversible Door
• Model NWXR473EVWW–White on White (Electric)
• Model NWXR473EVAA–Almond on Almond (Electric)
• Model NWXR473GVWW–White on White (Gas)
• Model NWXR473GVAA–Almond on Almond (Gas)

Termékspecifikációk

Márka: Hotpoint
Kategória: Szárítógép
Modell: NWXR473GVAA

Szüksége van segítségre?

Ha segítségre van szüksége Hotpoint NWXR473GVAA, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek


Útmutatók Szárítógép Hotpoint

Hotpoint

Hotpoint NWXR483GGWW Útmutató

14 Január 2025
Hotpoint

Hotpoint NT M11 9X3E IT Útmutató

30 December 2025
Hotpoint

Hotpoint NT M11 82XB IT Útmutató

15 December 2024
Hotpoint

Hotpoint NT M11 8X3K IT Útmutató

15 December 2024
Hotpoint

Hotpoint NT M11 9X3SKY IT Útmutató

15 December 2024
Hotpoint

Hotpoint NT M11 82K IT Útmutató

15 December 2024
Hotpoint

Hotpoint NTS M11 9X3E IT Útmutató

15 December 2024
Hotpoint

Hotpoint NT M11 8X3SKY IT Útmutató

15 December 2024
Hotpoint

Hotpoint NT M11 92WK IT Útmutató

15 December 2024
Hotpoint

Hotpoint EU NTDG92 SK IT Útmutató

14 December 2024

Útmutatók Szárítógép

Legújabb útmutatók Szárítógép

Bauknecht

Bauknecht traa prestige Útmutató

10 Április 2025
Bauknecht

Bauknecht TRK 9876 Útmutató

10 Április 2025
Asko

Asko TH208HW Útmutató

10 Április 2025
Zanussi

Zanussi ZTA 245 Útmutató

9 Április 2025
Bauknecht

Bauknecht TKL M11 72 Útmutató

9 Április 2025
Amana

Amana NGD4600YQ Útmutató

9 Április 2025
Whirlpool

Whirlpool awz 9479 Útmutató

9 Április 2025
AEG

AEG 65770IH3 Útmutató

7 Április 2025
Arçelik

Arçelik 901 KMP IG Útmutató

7 Április 2025
Arçelik

Arçelik 901 KMP I Útmutató

7 Április 2025