Használati útmutató IBEAM TE-DGH

Olvassa el alább 📖 a magyar nyelvű használati útmutatót IBEAM TE-DGH (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 19 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.6 csillagra

REV. 05/21/2018

TE-DGH/TE-DGHC (CMOS)

RAM 1500 (2009-2017)

RAM 2500 (2010-2017)

Replacement Tailgate Handle

with Camera

Removal and Installation

Instructions

Tools Needed: T30 torx bit, ratchet, 8mm

socket.

1.Start by lowering the tailgate and remove

the (8) T30 torx screws from the bed liner,

remove liner (Fig. A), remove access panel

(Fig. B), and place aside.

2.Now that you have access to the handle

assembly, disconnect harness running to lock

actuator and unclip (2) latch rods. (Fig. C)

3.Next, remove (2) 8mm nuts located below

latch connectors, then slide latch assembly

aside. (Fig. C)

4.Gently remove handle by lifting the handle

from the outside and slowly working it out.

5.Now that the handle is out of the tailgate,

you will have to swap the locking mechanism

out of the old handle to the new one.

6.Start by removing the (2) 8mm screws from

locking mechanism, and then remove

mechanism from handle. (Fig. D)

7.Now place the locking mechanism in the new

handle and secure it with the factory 8mm

screws.

Fig. A

Fig. B

Fig. C

Termékspecifikációk