Használati útmutató Interlogix TX-1510-01-1

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Interlogix TX-1510-01-1 (2 oldal) a Deur-/frame érzékelő kategóriában. Ezt az útmutatót 14 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.9 csillagra

P/N - 4662316 • REV D OCT12 1 •

DesignLine Recessed Door Contact Installation

Instructions

Introduction

This is the DesignLine Recessed Door Contact Installation

Instructions for model TX---1. The TX---1 is the 151001151001

industry’s most flexible supervised, recessed door contact

allowing a multitude of applications while hiding the transmitter

within a door frame. The contact uses a replaceable lithium

battery and should last five years under normal usage.

The contact comes with a standard flush-mount top and a

flanged top. Unscrew the top to access the battery or change

to a different top.

Battery installation

To install the battery, do the following:

1. Unscrew the top of the contact.

2. Carefully pull the circuit board out (Figure 1 ) of the below

contact. Before removing the circuit board, notice that it

fits inside a channel on the inside of the case. Do not pull

the circuit board unit by the antenna wire.

Caution: You must be free of static electricity before handling

sensor circuit boards. Touch a grounded, bare metal surface

before touching circuit boards or wear a grounding strap.

Figure 1: Battery installation

3. Slide the battery onto the circuit board unit with the plus

(+) side up.

4. Slide the circuit board unit into the contact. Make sure you

slide it back into the channel guides for proper fit with the

tamper switch facing up.

5. Screw the top back on the contact.

When replacing batteries, use only Panasonic Lithium CR23

batteries for replacement.

WARNING: The battery may explode if mistreated. Do not

recharge, disassemble, or dispose of in fire.

Mounting

It is important to select the proper placement of the recessed

transmitter and magnet. The transmitter has two separate tops

that allow a flush mount or screw mount in case you accidently

over drill the hole or require extra support to ensure the

transmitter does not move. The magnet does not have a

second flanged top so you must be careful to ensure that the

magnet is tightly in place once installed.

To mount the transmitter and magnet, do the following:

1. Install the CR2 battery if you have not already done so

(Figure 1 above ).

2. Select a location on the door frame for the TX---1510011

transmitter and magnet to be installed (Figure 2 on page

2). Use a marker to mark the placement and ensure that

the two holes you intend to drill are lined up directly across

from each other.

Tamper

switch

Antenna

Contact

Battery

Circuit

board

Termékspecifikációk