Használati útmutató Irritrol RS1000

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Irritrol RS1000 (12 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 15 ember találta hasznosnak.

Wireless RainSensor User’s Guide1

Table of Contents

Component Overview2

Quick Start Installation Instructions3

Detailed Installation Instructions

• Mounting the Receiver

• Wiring the Receiver

• Control Wire Connection

• Power Wire Connection

• Initial Receiver Testing

4

4

4

4

6

6

Installing the Sensor / Transmitter

• Testing the Signal Strength

• Installation

• Freeze Sensor Installation

7

7

7

7

Wireless RainSensor Operation

• Normal Operation

• Smart Bypass

• Power Down

• Receiver Learn Mode

• Attention Required

8

8

8

8

8

8

Sensor Adjustment

Battery Replacement

9

9

Changing Sensor/Transmitter Code9

Troubleshooting 10

Specications 11

Electromagnetic Compatibility12

Technical Support Numbers12

Congratulations on your purchase of the Irritrol Systems Wireless RainSensor. The

Wireless RainSensor components are designed for easy installation, so your sensor

controlled irrigation system will be up and running in minutes.

Before attempting the installation, please read through these instructions in their

entirety, and refer the installation instructions for your irrigation system controller/timer

in regards to connecting a rain sensor or rain switch. The Wireless RainSensor is

designed to work with either Normally Open or Normally Closed sensor circuits.

: Please note the following information regarding installation and use of Important

the Wireless RainSensor components:

• The RainSensor Receiver Module is designed to operate with 24 VAC power

only. Connecting the receiver wiring to 120/240 VAC power may result in severe

equipment damage.

• Installation methods must comply with all applicable national and local building

codes. If you are unsure about proper wiring practices, have a qualied contractor

perform the installation for you.

• The Receiver cover should always be used when the Receiver is installed outdoors.

• The Sensor/Transmitter should never be submerged in water or installed inside a

rain gutter.

Introduction

Wireless RainSensorTM

Models RS1000 & RFS1000 (+Freeze)

User’s Guide

RS1000

SENSOR STATUS

SIGNAL

POWER

Blinking Bypass ON

Blinking Attn. Reqd.

SENSOR STATUS

PRESS

Receiver

Sensor/Transmitter

Termékspecifikációk