Használati útmutató JANDY EE-Ti
JANDY
hőszivattyú
EE-Ti
Olvassa el alább 📖 a magyar nyelvű használati útmutatót JANDY EE-Ti (96 oldal) a hőszivattyú kategóriában. Ezt az útmutatót 4 ember találta hasznosnak és 2.5 felhasználó értékelte átlagosan 5.0 csillagra
Oldal 1/96
H0335800 Rev H
Jandy® Heat Pumps
Model EE-Ti
WARNING
This product must be installed by a licensed HVAC technician certied in heat
pump repair and maintenance by the jurisdiction in which the product will be installed where such
state or local requirements exists. The technician must possess and comply with all certications and
regulations regarding the purchasing, handling, transportation and reclamation of R410A refrigerant.
In the event no such state or local requirement exists, the installer or maintainer must be a
professional with sufcient experience in pool equipment installation and maintenance so that all of
the instructions in this manual can be followed exactly. Before installing this product, read and follow
all warning notices and instructions that accompany this product. Failure to follow warning notices
and instructions may result in property damage, personal injury, or death. Improper installation and/
or operation can create an electrical hazard which can cause serious injury, property damage, or
death. Improper installation and/or operation will void the warranty.
Page 1
ENGLISH
Zodiac
®
Jandy
®
Heat Pumps Model EE-Ti | Installation and Operation Manual
1.1 Introduction ......................................................... 3
1.2 Consumer Information and Safety ...................... 3
1.2.1 Spa/Hot Tub Safety Rules ............................ 3
1.2.2 Swimming Pool Energy Saving Tips ............ 4
1.3 Warranty ............................................................. 4
1.4 Codes and Standards ......................................... 4
1.5 Technical Assistance ........................................... 5
1.6 Materials Needed For Installation ....................... 5
1.6.1 Materials for All Installations ........................ 5
1.6.2 Recommended Materials for Installations .... 5
1.7 Specifications ...................................................... 5
1.7.1 General Specifications ................................. 5
1.7.2 Dimensions .................................................. 5
1.7.3 Technical Specifications ............................... 5
2.1 General Information ............................................ 5
2.2 Location Requirements ....................................... 5
2.2.1 Introduction .................................................. 5
2.2.2 Clearances ................................................... 7
2.2.3 Equipment Pad ............................................ 8
2.2.4 Condensation and Drainage ........................ 8
2.2.5 Lawn Sprinklers ........................................... 8
2.2.6 Roof Run-off ................................................. 8
2.2.7 Installation of Anchor Clamps ...................... 8
3.1 Plumbing Layout ................................................ 9
3.2 Water Connections at Heat Pump ...................... 9
3.3 Check Valve Installation ...................................... 9
3.4 Automatic Flow Control Valve ........................... 10
3.5 Multiple Unit Installation .................................... 10
3.5.1 Heat Pump and Heater Combination ......... 10
3.5.2 Multiple Heat Pump Connections ............... 10
4.1 General Information .......................................... 10
4.2 Main Power ....................................................... 16
4.3 Bonding ............................................................. 16
4.4 Pump Connection (Maintain Temp Feature) ..... 16
4.5 Optional Remote Controls ................................ 17
4.5.1 Connection to a Remote Pool-Off-Spa
Selector (3-Wire Connection) ..................... 17
4.5.1.1 Install the Remote Pool-Off-Spa
Selector ................................................ 17
4.5.1.2 Configure the Control Panel ................ 17
4.5.2 Two-Wire Connection to an AquaLink® RS
or TSTAT .................................................... 17
4.5.2.1 Configure the AquaLink RS Control
System ................................................. 17
4.5.2.2 Install the Remote TSTAT .................... 17
4.5.2.3 Configure the Control Panel ................ 18
4.5.3 Four-Wire Connection to AquaLink® RS
485 Communication ................................... 18
4.5.4 Connection to a Secondary User Interface 19
5.1 Initial Start-up Precautions ................................ 19
5.2 Operating the Controller ................................... 19
5.2.1 Off Mode .................................................... 19
5.2.2 Pool Mode - (Normal Heat) ........................ 19
5.2.3 Pool Mode - (Optional Maintain Heat) ........ 20
5.2.4 Spa Mode - (Normal Heat) ......................... 20
5.2.5 Spa Mode - (Optional Maintain Heat) ........ 20
5.3 Operating Features of Hybrid Units with
Optional Chiller ................................................. 20
5.3.1 Pool Mode - (Normal Chill) ......................... 20
5.3.2 Pool Mode - (Optional Maintain Chill) ........ 20
5.3.3 Spa Mode - (Optional Maintain Chill) ......... 21
5.4 User Setup Options .......................................... 21
5.4.1 Language Setup ......................................... 21
5.4.2 Temperature Scale Setup .......................... 21
5.4.3 Spa Timer Setup ........................................ 21
5.4.4 Display Light Setup .................................... 21
5.5 Set Point Lockout .............................................. 22
5.6 Water Pressure Switch Adjustment ................... 22
6.1 Water Chemistry ............................................... 23
6.2 Winterizing ........................................................ 23
6.3 Spring Start-Up ................................................. 24
6.4 Inspection and Service ..................................... 24
6.4.1 Owner Inspection ....................................... 24
6.4.2 Professional Inspection .............................. 24
7.1 Heat Pump Design ............................................ 25
7.2 Heat Pump Components and Operation ........... 25
8.1 Troubleshooting Guide...................................... 26
8.2 Diagnostics ....................................................... 27
9.1 Ordering Information ......................................... 28
9.2 Zodiac EE-Ti Heat Pumps Parts List ................ 28
9.3 Zodiac EE-Ti Heat Pumps Exploded View ....... 29
Termékspecifikációk
| Márka: | JANDY |
| Kategória: | hőszivattyú |
| Modell: | EE-Ti |
Szüksége van segítségre?
Ha segítségre van szüksége JANDY EE-Ti, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók hőszivattyú JANDY
17 Augusztus 2024
17 Augusztus 2024
15 Augusztus 2024
15 Augusztus 2024
15 Augusztus 2024
15 Augusztus 2024
28 Május 2024
17 Május 2024
Útmutatók hőszivattyú
- hőszivattyú REMKO
- hőszivattyú Remeha
- hőszivattyú Nibe
- hőszivattyú Dimplex
- hőszivattyú Junkers
- hőszivattyú Blaupunkt
- hőszivattyú Wita
- hőszivattyú Orima
- hőszivattyú Armstrong
- hőszivattyú Maxicool
- hőszivattyú Zodiac
- hőszivattyú AEG
- hőszivattyú Balay
- hőszivattyú Harmopool
- hőszivattyú Atlantic
Legújabb útmutatók hőszivattyú
6 Április 2025
6 Április 2025
6 Április 2025
6 Április 2025
6 Április 2025
4 Április 2025
4 Április 2025
3 Április 2025
30 Március 2025
28 Március 2025