Használati útmutató JANDY Stain Remover

Olvassa el alább 📖 a magyar nyelvű használati útmutatót JANDY Stain Remover (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 20 ember találta hasznosnak és 4 felhasználó értékelte átlagosan 5.0 csillagra

1.Attach Stain Remover

applicator head to pool pole.

2. Place rubber band around

lower of bottle (see picture). ⅓

Screw vent cap on gallon

container of diluted muriatic

acid (5:1 recommended). Use

chlorine for organic stains.

4. Submerge vinyl hose tubing

and applicator in pool, stretching

tube out all the way to remove

coils.

3. Place acid container on edge

of pool at deep end. Carry

applicator and pole to opposite

side of pool.

INSTRUCTIONS FOR USING JANDY STAIN REMOVER

Muriatic acid, or similar strong chemicals, can cause

bleaching or damage to pool surfaces. Do not hold Stain

Remover over stains for longer than 10 seconds at a time.

Keep Stain Remover moving. Do not allow more than

one (1) pint of chemical to enter pool in any one Stain

Remover session (usually not more than 1-3 minutes of

use). If multiple sessions are required, wait 3 days and

repeat. NOTE: Check pool chemistry before using Stain

Remover and after, then adjust chemistry accordingly.

STAIN REMOVER USER

CAUTION

Special Applications:

For rust and other stains use muriatic acid. For algae use liquid algaecides or

chlorine. Contact your pool dealer for additional information.

CAUTION:Muriatic acid is not recommended for vinyl lined swimming

pools. Substitute with liquid algaecides or chlorine.

KEEP OUT OF REACH OF CHILDREN. READ LABEL ON ACID

CONTAINER AND WARNING ON STAIN REMOVER. CAN CAUSE

SERIOUS INJURY OR DEATH.

WARNING:

Termékspecifikációk