Használati útmutató Kenwood CMOS-320

Kenwood Autó kamera CMOS-320

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Kenwood CMOS-320 (60 oldal) a Autó kamera kategóriában. Ezt az útmutatót 6 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Letöltés PDF

Oldal 1/60

CMOS-320

CMOS-220

UNIVERSAL MULTI-VIEW CAMERA/ UNIVERSAL REAR VIEW CAMERA

INSTRUCTION MANUAL

CAMÉRA MULTI-VUES UNIVERSELLE/ CAMÉRA DE RECUL UNIVERSELLE

MODE D’EMPLOI

UNIVERSAL MULTIVIEW-KAMERA/ UNIVERSAL RÜCKFAHRKAMERA

BEDIENUNGSANLEITUNG

UNIVERSELE MULTIVIEWCAMERA/ UNIVERSELE ACHTERUITRIJCAMERA

GEBRUIKSAANWIJZING

LYT2720-001A (W)

Take the time to read through this instruction manual.

Familiarity with installation and operation procedures will help you obtain the best performance

from your new Universal Camera.

For your records

Record the serial number, found on the back of the unit, in the spaces designated on the warranty card,

and in the space provided below. Refer to the model and serial numbers whenever you call upon your

Kenwood dealer for information or service on the product.

Model CMOS-320/CMOS-220 Serial number

US Residence Only

2 | CMOS-320/CMOS-220

• Beforenally      installing the unit, connect the wiring

temporarily,   making sure it is all connected up properly,

and and  the unit the system work.

• When mounting unit, none the  this   make sure  of   leads are

trapped      between this unit and the surrounding metalwork

orttings.

• Do     not mount this unit near the   heater outlet, where

it be would  aected by   heat, or near the  doors, where

rainwater    might splash onto it. (Never   install in locations

such danger      as the above because of the   of malfunction

due high to temperatures.)

• Beforedrilling     any mounting holes always check behind

where the the    you want to drill      holes. Do not drill into gas

line, line, wiring other important brake  electrical  or  parts.

• If        this unit is installed in the passenger compartment,

anchor   it securely so itdoes    not break free while the  car is

moving,     and cause injury or an accident.

• If     a      this unit is installed under front seat, make sure it does

not obstruct      seat movement. Route all leads and cords

carefully the sliding around      mechanism so they do not get

caught  or pinched in    a the mechanism and cause short

circuit.

Care and maintenance

• When the       a  product gets dirty, wipe dry with silicon cloth

or          soft cloth. If it is seriously stained, remove stain with

a   acloth moistened with neutral   cleaner and then wipe

the     a   a cleaner away. Do not use hard cloth and/or volatile

substance such lacquer  as    thinner or alcohol, scratches,

deformation, damage  degradation and/or  may result.

• When component gentlya lens    gets dirty, wipe witha soft

cloth     moistened with water. Do not rub a   with dry cloth to

preventscratchingthelens.

Installation Procedure

1 Topreventashortcircuit,removethe fromthekey

ignitionanddisconnectthe battery.-

2 Maketheproperinputandoutputwireconnections

foreachunit.

3 Connectthewiringharnesswiresinthefollowing

order:ground,ignitionandcameraunit.

4 Installtheunitinyourcar.

5 Reconnectthe battery.-

WARNING

To prevent injury or fire, take the following

precautions:

• To a     prevent short circuit, never put or leave  any metallic

objects   (such as coins or   metal tools) inside theunit.

• Installation and specialist      wiring of this product require 

skill     and experience. To assure your safety,  aplease request

specialist technician    to install the unit.

• When the the  a   you make hole to install   camera, check 

location tanks and and  of pipes,   wiring   avoid touching

them. Otherwise the    it may cause re.

• When  a  a     you make hole with drill, use goggles to protect

youreyes.

CAUTION

To prevent damage to the product, take the

following precautions:

• Make     sure to ground the unit toa    negative 12V DC power

supply.

• When replacing new the a   afuse, only use   fuse with 

prescribed rating. Using the wronga  fuse with    rating may

cause to  your unit malfunction.

• Do       not use your own screws. Use only the  screws provided.

If use you        the wrong screws, you could damage the unit.

NOTE

• A    a  rear view camera is camera that provides symmetrical

images in the      same way as rear and  side view mirrors.

• Connection ato TVwith     an RCA video input is possible,

but   conrm whether the TV you use a  has reverse gear

connection function.

• This product is        designed to supplement the driver’s rear

view,    but the camera images do     not show all dangers and

obstacles. sure look Be  to behind    you when reversing to

conrm the view.

• This product  a      features wide-angle lens, so the near view

is far   wide and the view     ais narrow, which may create

false   sense of distance. Be     sure to look behind you when

reversing the view.  to conrm 

• Do    not wash your car with     an automatic car wash or

high-pressure  water as it      may result in water entering the

camera camera  or the  falling o.

• Check camera bracket  installation before driving.

 Are  the screws loose?

-   Is the camera bracket rmly secured?

-      If the rear view camera comes loose    while you are driving

it   may cause an accident.

Before Use/ Installation Procedure

CMOS-320/CMOS-220 | 3

ENGLISH

• Lay     the cords by avoiding high-temperature areas. Use

corrugated tubes for     wiring inside the engine room. Ifa

cord contacts a    high-temperature area of the vehicle, the

coating melt short-circuiting, may   and cause   which may

lead a to re or electric shockhazard.

Accessories

WARNING

• If          you connect the ignition wire (Red) to the car chassis

(Ground),   a      you may cause short circuit, that in turn may

starta         re. Always connect those wires to the power source

running the through  fuse box.

• Do  not cut out      the fuse from the ignition wire (Red). The

power   supply must be connected to the   wires via the fuse.

CAUTION

• If    your car’signition does not     have an ACC position, connect

the ignition wires turned   a     to power source that can be  on

and  o with the       ignition key. If you connect the ignition

wire voltage a   a to power source with constant   supply, as

with     battery wires, the battery may die.

• If          the fuse blows, rst make sure the wires aren’t touching

to cause short a         circuit, then replace the old fuse with one

with  the same rating.

• Insulate   unconnected wires with vinyl   tape or other similar

material.  a       To prevent short circuit, do not remove the caps

on ends the       of the unconnected wires or the terminals.

• After         the unit is installed, check whether the brake lamps,

blinkers, wipers, etc.     on the car are working properly.

• Install    so that it does not     obstruct the rear eld of view.

• Install    so that it does not     protrude from the side of thecar.

• Do      not perform installation in rain or fog.

• When humidity the the    is high, dry    surface to which   unit is

to   be attached before installing.

• Moisture on      the attachment surface reduces adhesive

strength, the coming    which may lead to  unit o.

• Do    not attach the camera bracket   to areas on the  car body

treated    with uorocarbon resin, or glass.

• May    result in the rear view  camera falling o.

- Do     not apply water to the unit.

- Do     not expose the unit to rain.

- Do      not subject the camera to unnecessary force.

- Thoroughly for     clean where tape is used    sticking on the

unit.

• Refer   to the Instruction’s manual    for details on connecting

the other then connections  units,  make correctly.

• Secure        the wiring with cable clamps or adhesive tape.

To       protect the wiring, wrap adhesive tape around them

where    they lie against metal parts.

• Route and secure   all wiring so it    cannot touch any moving

parts,   such as the gear    shift, handbrake and seat rails.

• Do          not route wiring in places that get hot, such as near the

heater outlet.    If the insulation of     the wiring melts or gets

torn,  a there is danger of     the wiring short-circuiting to the

vehiclebody.

• When replacing the       fuse, be sure to use only   fuse of the

rating the holder.  prescribed on  fuse

• To    minimize noise locate the TV   antenna cable, radio

antenna cable and cable each   RCA     as far away from  other

aspossible.

Grommet..........1

Camerabracketclampingscrew..........1

Camera(withcamerabracket)..........1

Switchunit..........1

Double-sideadhesivetape..........1

CMOS-320 only

Power ..........1cord

CMOS-320  CMOS-220

Termékspecifikációk

Márka:	Kenwood
Kategória:	Autó kamera
Modell:	CMOS-320

Szüksége van segítségre?

Ha segítségre van szüksége Kenwood CMOS-320, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek

Az Ön neve*

Az Ön e-mail címe*

Írja ide kérdését

Útmutatók Autó kamera Kenwood

Kenwood DRV-A301W Útmutató

2 Július 2024

Kenwood DRV-N520 Útmutató

30 Június 2024

Kenwood CMOS-320 Útmutató

28 Június 2024

Útmutatók Autó kamera

Legújabb útmutatók Autó kamera

Garmin nuviCam LMTHD Útmutató

15 Január 2025

Alpine HCE-C257FD Útmutató

12 Január 2025

Sencor SCR 4100 Útmutató

1 Szeptember 2024

Sencor SCR 2100 Útmutató

1 Szeptember 2024

Orion DVR-950FHD Útmutató

24 Augusztus 2024

Top Dawg DVR Dash cam Útmutató

24 Augusztus 2024

Top Dawg Dual DVR Dash cam Útmutató

23 Augusztus 2024

Orion DVR-GP4000FHD Útmutató

23 Augusztus 2024

Orion DVR-DC888FHD Útmutató

23 Augusztus 2024

Roadhawk HD Útmutató

23 Augusztus 2024