Használati útmutató Kenwood KTC-V500E

Kenwood Antenna KTC-V500E

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Kenwood KTC-V500E (32 oldal) a Antenna kategóriában. Ezt az útmutatót 12 ember találta hasznosnak és 2 felhasználó értékelte átlagosan 4.5 csillagra

Oldal 1/32
KTC-V500E
TV TUNER page 2 - 53
INSTRUCTION MANUAL
SYNTONISEUR TV page 6 - 93
MODE D’EMPLOI
TV-TUNER Seite 10 - 133
BEDIENUNGSANLEITUNG
TV-TUNER blz 14 - 17 3
GEBRUIKSAANWIJZING
SINTONIZZATORE TV pagina 18 - 213
ISTRUZIONI PER L’USO
SINTONIZADOR TV página 22 - 253
MANUAL DE INSTRUCCIONES
SINTONIZADOR TV página 26 - 293
MANUAL DE INSTRUÇÕES
© PRINTED IN JAPAN B64-2143-00 (E) (DT)
SI DICHIARA CHE:
Il Sintonizzatore TV Kenwood per auto, modello
KTC-V500E
risponde alle prescrizioni dell'art. 2 comma 1 del D.M. 28 agosto 1995,
n. 548.
Fatto ad Uithoorn il (21 settembre 2001)
Kenwood Electronics Europe B.V. Amsterdamseweg 37 1422 AC
Uithoorn The Netherlands
Installation
2
Securing to audio board
(Accessory F)
Installation the TV Tuner Unit
Accessories
G
F
E
A
B
C
(Accessory G)
(Accessory E)
D
The use of any accessories except for those provided might result in damage to the unit.
Make sure only to use the accessories shipped with the unit, as shown above.
3
Installing the Antenna Units
Attach the antenna to the inner glass surface of the rear window using double-sided
tape. Carefully check the installation location as the tape can only be stuck on once.
If the surface temperature of the glass of the rear window is low, warm it by turning
on the power of the rear defogger.
A cold window glass surface will weaken the adhesive strength of the double-sided
tape.
Also, if installation inside the cabin is performed on a day with high humidity or when
it is raining, the high humidity level will weaken the adhesive strength of the double-
sided tape.
Do not install the antenna in a location where it may obstruct the field of view during
driving, such as on the windshield.
Check the location where the antenna is to be
attached.Clean off any grease or dirt from the
installation location using the supplied glass
cleaner (Accessory B), clean the area with water
and allow to dry.
Clean the glass thoroughly as failure to
clean the glass can not only weaken the
adhesive strength of the double-sided
tape, but may also cause it to come loose.
Remove the protective strips from the antenna
parts and the back of the antenna unit.
Attach the double-sided tape of the antenna
parts and the antenna unit to the rear windshield
glass. Attach the double-sided tape by firmly
pressing down from the top. Secure cables
using the supplied clampers.
After attaching the antenna with the double-
sided tape, allow it to sit undisturbed for 24
hours. Take care not to apply force to the
antenna or allow it to get wet during this time.
Wire the antenna cable to TV tuner unit.
5
4
3
2
1
Rear seat
Rear window
Bundle cables with the
clamper bar
(Accessory C)
Antenna parts
Antenna unit
Incar antennas have a lower reception sensitivity than antennas intended for outside
mounting. The picture may not appear or may be disturbed if the signal in your area is
weak.

Termékspecifikációk

Márka: Kenwood
Kategória: Antenna
Modell: KTC-V500E

Szüksége van segítségre?

Ha segítségre van szüksége Kenwood KTC-V500E, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek