Használati útmutató King WR120-B-KIT

King Termosztát WR120-B-KIT

Olvassa el alább 📖 a magyar nyelvű használati útmutatót King WR120-B-KIT (4 oldal) a Termosztát kategóriában. Ezt az útmutatót 20 ember találta hasznosnak és 10.5 felhasználó értékelte átlagosan 4.0 csillagra

Letöltés PDF

Oldal 1/4

Page 1

This thermostat is designed to reinforce positive energy habits while limiting landlord energy expenses. For use on 120 Volt AC and a total of 16 Amps

load inductive Continuous.

Check the voltage to make sure you have the right thermostat for your heater voltage. A 1-pole or single-wide breaker indicates a 12 Volt circuit.

Be safe and smart! Electricity can cause severe injury or death if not treated with respect and caution.

This thermostat will provide years of comfort control for your family in use with small fan driven electric heaters, baseboards, radiant ceiling, wall panel

heaters, cove heaters or any line voltage resistance heating systems that do not have an electric motor over 1/3 hp.

OPERATION:

The is a precision electronic thermostat and uses a very sensitive thermistor near the bottom to sense room air

temperature, sending the information on the microprocessor. As the temperature drops, the information sent will indicate if heat is needed.

This saves energy and provides the best temperature control of an area.

The thermostat has an extra contact terminal block for remote set back to 40°F/5°C. Intended for window or door open

contacts. The 40°F/5°C temperature is a ﬁxed setting and not adjustable. The maximum operating temperature is stopped at 74°F/23°C, helping to

change human behaviors that increase energy costs.

INSTALLATION:

This line voltage device should be installed and serviced by a qualiﬁed electrician. The thermostat has been designed to mount to a standard

2” x 4” elctrical outlet box. Leveling of the thermostat is not required. #6-32 Phillips head mounting screws are provided.

Mount the thermostat in an open area about 5 feet above the ﬂoor, avoiding outside walls as they are too cold and will inhibit the thermostats

performance. A general rule of thumb is to place the thermostat above the wall switch for that room. This works well for most bedrooms, making

it very convenient to turn the heat lower upon leaving. Avoid mounting the thermostat where there may be plumbing pipes in the wall or placing

a lamp or TV too close to the thermostat. Heat from such items negatively affect thethermostats performance.

SPECIFICATIONS:

Temperature range: 40°F/5°C to 74°F/23°C

Temperature Default: Your set point 60°F/16°C

to 40°F/5°C

Display Format: Liquid Crystal Display (LCD)

Display size: Large Format

Sample Rate: Every 60 seconds

Heat indicator: LCD “heater on”

Window Contacts OPEN. (LCD) OPN

Relay Rating: 16 Amps inductive or resistive

Accuracy: ± 0.9°F/±0.5°C

Maximum Amps: 16 inductive continuos

Maximum Watts: 1875 @ 120V

3328 @ 208V

3840 @ 240V

Total inductive motor load combined can not exceed

16 amps

Minimum Watts:0

Power Supply Rated 208/240 VAC

Operating Range 200 to 250 VAC

Page 2