Használati útmutató Korg GA Custom
Olvassa el alább 📖 a magyar nyelvű használati útmutatót Korg GA Custom (8 oldal) a DJ Gear kategóriában. Ezt az útmutatót 16 ember találta hasznosnak és 8.5 felhasználó értékelte átlagosan 5.0 csillagra
Oldal 1/8
Precautions
Location
Using the unit in the following locations can result in a malfunction.
• In direct sunlight.
• Locations of extreme temperature or humidity.
• Excessively dusty or dirty locations.
• Locations of excessive vibration.
• Close to magnetic elds.
Power supply
Be sure to turn the power switch to OFF when the unit is not in use.
Remove the battery in order to prevent it from leaking when the unit is
not in use for extended periods.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception
interference. Operate this unit at a suitable distance from radios and
televisions.
Handling
To avoid breakage, do not apply excessive force to the switches or
controls.
Care
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use
liquid cleaners such as benzene or thinner, or cleaning compounds or
ammable polishes.
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If liquid gets
into the equipment, it could cause a breakdown, re, or electrical shock.
Be careful not to let metal objects get into the equipment.
THE FCC REGULATION WARNING (for USA)
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If items such as cables are included with this equipment, you must
use those included items.
Unauthorized changes or modication to this system can void the
user’s authority to operate this equipment.
Notice regarding disposal (EU only)
If this symbol is shown on the product, manual, battery, or
package, you must dispose of it in the correct manner to avoid
harm to human health or damage to the environment. Contact
your local administrative body for details on the correct dis-
posal method. If the battery contains heavy metals in excess
of the regulated amount, a chemical symbol is displayed
below the symbol on the battery or battery package.
Thank you for purchasing the Korg GA Custom chromatic tuner.
Merci d’avoir choisi l’accordeur Chromatique GA Custom de Korg.
Vielen Dank, dass Sie sich für das chromatische Stimmgerät GA
Custom von Korg entschieden haben.
Gracias por comprar el anador cromático GA Custom de Korg.
このたびは、コルグ クロマチック・チューナー GA Customを
お買い上げいただきまして、まことにありがとうございます。
GA Custom
CHROMATIC TUNER
アフターサービス
修理および商品のお取り扱いについてのご質問、ご相談は、お客
様相談窓口へお問い合わせください。
お客様相談窓口
PHS等一部の電話ではご利用できません。固定電話また
は携帯電話からおかけください。
受付時間 月曜～金曜 10:00 ～ 17:00
（祝祭日、窓口休業日を除く）
●サービス・センター :
〒168-0073 東京都杉並区下高井戸1-15-12
■お願い
1.
保証書に販売年月日等の記入がない場合は無効となります。記入でき
ないときは、お買い上げ年月日を証明できる領収書等と一緒に保管し
てください。
2.
保証書は再発行致しませんので、紛失しないように大切に保管してく
ださい。
コルグ GA Custom 保証書
本保証書は、上記の保証規定により無償修理をお約束するものです。
お買い上げ日 年 月 日
販売店名
IMPORTANT NOTICE TO CONSUMERS
This product has been manufactured according to strict specica-
tions and voltage requirements that are applicable in the country
in which it is intended that this product should be used. If you have
purchased this product via the internet, through mail order, and/or
via a telephone sale, you must verify that this product is intended
to be used in the country in which you reside.
WARNING: Use of this product in any country other than that for
which it is intended could be dangerous and could invalidate the
manufacturer’s or distributor’s warranty.
Please also retain your receipt as proof of purchase otherwise your
product may be disqualied from the manufacturer’s or distribu
-
tor’s warranty.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
CAN ICES-3 B / NMB-3 B.
The new seing will blink three times in the note name display indicat-
ing the calibration has been set. The GA Custom will automatically
return to tuner mode.
The calibration seing will be remembered even if the power is turned o. How-
ever, this seing will be reset to the factory default if the baeries are removed.
Setting the display mode
The GA Custom allows you to choose one of three display mode seings.
The factory seing is Regular mode.
1. PresstheDISPLAYbuon.
The current seing will blink for several seconds in the note display
(Light → Blink).
2. When the seing is shown in the note name display, press the
Displaybuonagaintosetthedisplaymode.
Each time you press the DISPLAY buon you will cycle through the
following seings.
1: Regular
Tune your instrument until the green LED in the LED meter is lit. The
blue LEDs at the right will light up if the pitch is high, and the blue
LEDs at the boom will light left if the pitch is low.
The pitch is sharp.In tune.The pitch is flat.
2: Strobe
Tune your instrument until the LEDs stop running. Since the strobe
meter has higher precision, it allows you to tune with greater accuracy.
The illumination will ow from left to right if the pitch is high, or from
right to left if the pitch is low.
The pitch is sharp.In tune.The pitch is flat.
3: Half-strobe
Tune your instrument until the LEDs stop running and only the green
LED is lit. The blue LEDs at the right will strobe if the pitch is high,
and the blue LEDs at the left will strobe if the pitch is low. When the
pitch is in tune, only the green LED is lit.
The pitch is sharp.
In tune.
The pitch is flat
.
3. Afteryou’vechosenthedisplaymodeyouwouldliketouse,wait
approximatelytwosecondswithoutpressinganybuons.
The note name display will blink two times, the display mode will
be set, and the GA Custom will automatically return to tuner mode.
The display mode seing will be remembered even if the power is turned o.
However, this seing will be reset to the factory default if the baeries are removed.
Specications
Scale: 12-note equal temperament
Range(sinewave): A0 (27.50 Hz)–C8 (4186 Hz)
Referencepitch: 436–445 Hz (1 Hz steps)
Precision: +/-0.1 cent
Inputimpedance: 1 M-ohm
Powersupply: Two AAA manganese dry cell, alkaline dry cell or NiMH
rechargeable baeries
Baerylife: approximately 50 hours: manganese dry cell
(A4 input continuously, display mode: Regular)
Dimensions: 99 mm(W) X 65 mm(D) X 16 mm(H)
3.90’’ (W) X 2.56’’ (D) X 0.63 ’’ (H)
Weight: 83 g/2.93 oz. (including baeries)
Includeditems: Two AAA baeries
• Specications and appearance are subject to change without notice for
improvement.
Parts of the GA Custom
Installing the batteries
Make sure to turn the power o before you install or replace the baeries.
When the baeries are almost depleted, the green LED in the tuning
LED meter will blink. When this happens, install new baeries as soon
as possible to ensure accurate tuning
1.Openthebaerycover,locatedonthebackofthetuner
2.Insertthebaeries,makingsuretoobservethecorrectpolarity.
3. Returnthebaerycovertoitsoriginalposition.
Battery
cover
Preparation
Connect the instrument to be tuned to the INPUT jack, and connect the
eect pedal, amp, etc., to the OUTPUT jack.
Turn o the power of all devices before you make any connections to avoid
damaging your equipment.
The INPUT and OUTPUT jacks are mono. Stereo (TRS) cables will not work.
When using the internal mic for tuning, make sure nothing is connected
to the INPUT and OUTPUT jacks. The internal mic cannot be used when
a device is connected.
Tuning
1. Pressthepowerbuon.Thepowerwillturnon/oeachtimeyou
pressthisbuon.
The calibration seing will appear in the note name display for a few
seconds (light blinking). →
In addition, the green LED in the tuning LED meter will light up.
If the power is left on for approximately 3 minutes without any user
input, it will turn o automatically.
2. Ifdesired,adjustthecalibrationand/orselectthedisplaymode.
3. Playasinglenoteonyourinstrumentandtuneitsothatthedesired
noteappearsinthenotenamedisplay.
The note name closest to the entered note appears in the note name
display.
4. TuneyourinstrumentusingthetuningLEDmeter.
The method for indicating whether your instrument is in tune, sharp
or at depends on which display mode you choose.
Even if the pitch is within the range of detection, it may not be possible to detect
the pitch of an instrumental sound that contains large numbers of overtones
or a sound that has a rapid decay.
Adjusting the calibration
The GA Custom comes from the factory with the calibration set to
A=440Hz. If an adjustment is necessary, you can do so within a range
of 436–445Hz.
1. PresstheCALIBbuon.
The current calibration seing will blink for several seconds in the
note namedisplay (Light → Blink).
2. While the current calibration seing is shown in the note name
display,presstheCALIBbuonagaintoadjusttheseing.
Each time you press the CALIB buon you will cycle through the
following seings.
0: 440 Hz, 1: 441 Hz, 2: 442 Hz, 3: 443 Hz, 4: 444 Hz, 5: 445 Hz,
6: 436 Hz, 7: 437 Hz, 8: 438 Hz, 9: 439 Hz
3. Afteryouhaveselectedyourdesiredcalibrationseing,waitap-
proximatelytwosecondswithoutpressinganybuons.
CALIB buttom
DISPL buttoAY
m
Power button
Battery cover
Note name
displa
y
Internal mic
OUTPUT jack
(mono)
INPUT jack (mono)
Tuning LED meter
Termékspecifikációk
| Márka: | Korg |
| Kategória: | DJ Gear |
| Modell: | GA Custom |
Szüksége van segítségre?
Ha segítségre van szüksége Korg GA Custom, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek
Útmutatók DJ Gear Korg
14 December 2024
8 Október 2024
27 Szeptember 2024
26 Szeptember 2024
24 Szeptember 2024
17 Szeptember 2024
15 Szeptember 2024
4 Szeptember 2024
3 Szeptember 2024
2 Szeptember 2024
Útmutatók DJ Gear
- DJ Gear The T.mix
- DJ Gear Elektron
- DJ Gear Motu
- DJ Gear Bigben Interactive
- DJ Gear Brigmton
- DJ Gear Mixars
- DJ Gear American Audio
- DJ Gear Vocopro
- DJ Gear IMG Stage Line
- DJ Gear BeamZ
- DJ Gear Power Dynamics
- DJ Gear Skytec
- DJ Gear PLAYdifferently
- DJ Gear Thorens
- DJ Gear Konig
Legújabb útmutatók DJ Gear
15 Március 2025
12 Január 2025
12 Január 2025
8 Január 2025
6 Január 2025
6 Január 2025
6 Január 2025
6 Január 2025
6 Január 2025
6 Január 2025