Használati útmutató Microchip HV809

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Microchip HV809 (11 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 8 ember találta hasznosnak és 4.5 felhasználó értékelte átlagosan 3.7 csillagra

Oldal 1/11
Supertex inc.
Supertex inc.
www.supertex.com
Doc.# DSAN-AN-H36
A040313
AN-H36
Application Note
HV809 EL Lamp Driver for Battery Powered
and Off-line Equipment
by Scott Lynch, Senior Applications Engineer
Introduction
The Supertex HV809 is designed to drive large lamps at
high brightness. It can operate from a rectied/ltered 120V
AC power line or from any DC source in the range of 50 to
200V. For use in battery powered applications, an external
DC-DC converter is required.
This application note is divided into two sections, portable
applications and off-line applications. Section I describes the
operation of the Supertex’s HV809 EL lamp driver for a battery
operated (4 AA cells) application to drive a 12.5in2 EL lamp
to a brightness of 15ft-lm. Details are provided for designing
a high voltage output DC-DC converter. Applications can be
for PDA’s, GPS’s, hand held computers, and other portable
devices requiring high brightness EL backlighting. Section II
describes the HV809 operating from a 120V AC line to drive
a 100in2 EL lamp to a brightness of 20ft-lm. Applications can
be signage, courtesy lighting, and accent lighting.
Section I - Portable Applications
The basic circuit conguration is shown in Figure 1. There
are many different implementations in designing the DC-DC
converter. In this design, an inexpensive 555 timer IC was
used for the DC-DC converter. Details of the converter are
discussed in a later section.
Lamp Driver Circuit and Operation
The Supertex HV809 is capable of driving EL lamps of up to
350nF at 400Hz. Input supply can be any DC voltage source
from 50 to 200V. The HV809 supplies the EL lamp with an
AC square wave with a peak-to-peak voltage of two times
the input DC voltage.
The HV809 incorporates a lamp drive oscillator with frequency
controlled by a single resistor, REL-osc. The oscillator controls
the lamp driver output section, which consists of 4 transistors
arranged in a full bridge conguration as shown in Figure 2.
Figure 2: HV809 Lamp Driver
Figure 1: HV809 for Portable Applications
A1
A2
GND
REL
HVIN
VDD
OSC2
OSC1
HV809
DC-DC
Converter
CDD
REL
EL
Lamp
Batteries
HVOUT
VIN
Linear
Regulator
GND
HVIN
VDD
OSC2
OSC1
REL-Osc
Q
Q
Q
VA
Q
Logic
and
Osc
VB

Termékspecifikációk

Márka: Microchip
Kategória: nincs kategorizálva
Modell: HV809

Szüksége van segítségre?

Ha segítségre van szüksége Microchip HV809, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek




Útmutatók nincs kategorizálva Microchip

Útmutatók nincs kategorizálva

Legújabb útmutatók nincs kategorizálva

MOZA

MOZA SR-P Útmutató

10 Április 2025
CaterChef

CaterChef 445001 Útmutató

9 Április 2025
IFM

IFM E40581 Útmutató

9 Április 2025
Livn

Livn Bolt Útmutató

9 Április 2025
Livn

Livn Beats Útmutató

9 Április 2025
IFM

IFM O3R252 Útmutató

9 Április 2025