Használati útmutató Midland MicroMobile MXAT01VP

Midland rádió MicroMobile MXAT01VP

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Midland MicroMobile MXAT01VP (1 oldal) a rádió kategóriában. Ezt az útmutatót 9 ember találta hasznosnak és 5 felhasználó értékelte átlagosan 4.3 csillagra

Oldal 1/1
5900 Parretta Drive KANSAS CITY, MO 64120
PHONE: (816) 241 8500 5713- FAX: (816) 241-
EMAIL: mail@midlandradio.com
WEBSITE: midlandusa.com
Midland Radio Corporation
midlandusa.com
10 16/ /2022
MXAT01 NMO Mount Assembly Diagram
1. The MXAT01 NMO mount is designed for mounting brackets or surfaces up to 1/2" thick.
2. The MXAT01 NMO mount is designed to be installed in a 1/2" hole, commonly used for 3/8” stud mount
CB antennas.
3. Part C should be adjusted so the center conductor on the Part D NMO interface extends 9/32” to 5/16”
beyond the mounting surface, or just above the top surface of Part A when installed.
4. Use the hex head on the Part D NMO interface to hold it in position while Part A is installed and tightened.
5. Part A is installed on top of the bracket or mounting surface with the wrench flats up and the O-ring
down. The rubber O-ring on the bottom of part A acts as a seal to prevent water entering the mounting
s - urface hole. Maximum torque: 32 lb ft.
6. The hex head can also be used to hold the NMO interface in position while tightening the PL259
connector, Part F, by hand.
7. The center conductor of Part D should end up 1/32” to 1/16” proud of Part A to properly interface with
the MXAT01 antenna. Tighten the antenna by hand, to just snug.

Termékspecifikációk

Márka: Midland
Kategória: rádió
Modell: MicroMobile MXAT01VP

Szüksége van segítségre?

Ha segítségre van szüksége Midland MicroMobile MXAT01VP, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek